Which of the following does the ignition system use to convert relatively low-voltage and high-current flow into very high-voltage and very low-current flow?

Select one:

The original ignition system found in vehicles was the:

Select one:

With the higher voltages that today's electronic ignition systems have to endure because of the increased spark plug gaps and leaner air fuel mixtures, the insulation material on the high-tension leads is now much ________ than in earlier models.

The ________ connect the coil to the distributor cap center terminal and the distributor cap side terminals to the terminals on the top of the spark plugs.

Select one:

The primary winding of the ignition coil has approximately _______ turns of enameled copper wire.

Select one:

Tech A states that in a contact breaker point ignition system, the number of lobes on the distributor shaft is equal to the number of cylinders. Tech B states that number of lobes is twice the number of cylinders. Who is correct?

Select one:

The vacuum advance mechanism controls ignition advance in relation to engine ________.

Select one:

________ is routed from the carburetor to a spring-loaded diaphragm housing attached to the distributor.

Select one:

As the rotor turns inside the distributor cap, the high-voltage electrical surges take place successively for each cylinder according to the firing order.

Select one:

________ are used in virtually every type of ignition system except the contact breaker point system.

Select one:

Tech A says that a Hall-effect sensor can be used in an electronic ignition system. Tech B says that an optical-type sensor can be used in an electronic ignition system. Who is correct?

Select one:

Early electronic ignition systems included an ignition module and a triggering device coupled with a ________.

Select one:

The reluctor or trigger wheel is mounted to any of the following EXCEPT the:

Select one:

At higher engine speeds, the time available to burn the air fuel mixture _______, while the time required to completely burn the mixture remains essentially the same.

Select one:

As engine rpm increases, the ignition timing must:

Select one:

Spark plugs are identified by three different features: thread size or diameter, reach or length of the thread, and heat range or ________.

Select one:

The two sets of windings in an ignition coil are the _______ winding and the _______ winding.

Select one:

What ignition part is this?

What Ignition part is this?

What Ignition part is this?