NEW
Font size
WorksheetsHaas 6.2
Total questions: 16
Worksheet time: 8mins
The X - diameter measure button is pushed to
Measure the diameter of your workpiece
Measure the distance from the chuck to the tailstock
Deploy the X-ray laser system
Record the position of the tool tip while setting a tool offset
The Z - face measure button is used to....
Define the turret distance to the tailstock
Set the work offset position for the machine
Set the door swing shut position
Determine if you've washed your hair properly
The most important thing to remember when indexing the turret...
Check if the turret is properly aligned
Unclamp the turret
Rotate clockwise or anti clockwise
Move the turret away from any obstructions
When a CNC turning centre has a crash
Press the rewind button
Don't inspect the turret again
No big deal press cycle start again
This will usually cause more damage then you think
Why is the rotational energy released in a lathe crash usually higher than a milling machine.
Because CNC lathes are bigger
Because there are more angled surfaces
Because the spindle rotates quicker
Because the workpiece is spinning in a lathe and only the tool spins in a mill
The quickest way to stop the machine in an emergency is......
Hit the E-stop
Press the reset button repeatedly
Run round the machine and switch it off
Think positive thoughts
When you push the emergency stop, what happens
All the buttons blink and the american national anthem plays
Alarms sound
the machine stops moving and the program stops moving
Machine sends message to supervisor
You should push the E-stop anytime
You feel like you need a break and want a snack
If you think the machine is going to crash
If you want to pause the program
You want to change the program to edit mode
If you need to stop the machine in the middle of a cut and the machine isnt in danger of a crash
Press the E-stop
Just press reset
Press power up
Press feed hold instead of emergency stop
If your going to work inside the machine you should press the emergency stop
True
False
When you press feed hold
Stops the tailstock
All programs and feed moves are not allowed to run
Stop eating lunch and return to work
All axis motion stops
When you press fed hold
Machine decelerates to zero but axis keep moving
Pauses the line of code and does not reset the code
Pauses for 5 seconds
Runs a series of internal checks
M08 and M09 commands are used to...
Turn the flood coolant on within the program but on within the part
Initiate a macro program
Automatically clamp and unclamp the chuck
Activate the high pressure through tool coolant
How do you turn the coolant on and off manually
Use a bucket to throw coolant into the machine
Press program edit and jog keys automatically
Select manual coolant activation
Press the coolant soft key
If you turn the coolant off for whatever reason you must always remember.....
To make a mental note where within the program you turned the coolant off
Check coolant level readout
To activate the high-pressure coolant pump
To turn the coolant back on before the current tool begins cutting again
The jog handle can be used to......
Alternate between memory and MDI modes
Get a good workout without leaving your machine
Non of the above
Move each of the machine axis individually
