WorksheetsVinyl Cut 103
Total questions: 12
Worksheet time: 6mins
What is the first step to take after the vinyl has been cut by the vinyl cutter?
Apply transfer tape immediately
Weed out the excess vinyl
Remove the entire sheet from the cutting mat
Transfer the design to the target surface
Which tools are commonly used for weeding vinyl? Select all that apply
Scissors
Tweezers
A weeding hook
A ruler
What is the purpose of weeding the vinyl?
To remove the design
To remove excess vinyl
To make the design smaller
To straighten the edges of the design
When should transfer tape be applied to the vinyl?
Before weeding
After removing the design from the backing paper
After transferring the design to the target surface
After weeding but before removing the design from the backing paper
Why did the vinyl cutter go to therapy?
It had separation issues with the designs.
It couldn't find its groove.
It felt stuck in a sticky situation.
What is the purpose of using transfer tape?
To protect the vinyl from damage
To make weeding easier
To hold the design together while transferring it to the target surface
To trim the edges of the design
How should you apply pressure when using transfer tape?
Evenly across the entire design
Only on the edges of the design
Only on the center of the design
No pressure is needed
Which side of the transfer tape should be facing the vinyl design?
Transfer tape is not necessary
Either side will work
The non-adhesive side
The adhesive side
Why did the vinyl cutter become a hairstylist?
It had a sharp sense of style.
It was always a cut above the rest.
It knew how to make precise cuts.
How should you apply the vinyl design with transfer tape onto the target surface?
From one corner to the opposite corner diagonally
From the center outward
From one side to the other side horizontally
In a circular motion
After applying the transfer tape, what is the next step before transferring the design to the target surface?
Apply more pressure to the transfer tape
Cut the transfer tape to size
Remove the vinyl's backing paper
Weed the vinyl again
What should you do if the vinyl design doesn't stick to the transfer tape properly?
Apply more pressure and rub the tape onto the vinyl
Remove the transfer tape and start over
Use a different type of transfer tape
Continue with the transfer process regardless
