This diagram shows a decorative top piece of a shelving unit. This has to be reproduced many times.

Name the marking out aid that is used to ensure all the decorative top pieces are marked out identically.

Slot A, shown, is cut using hand tools. The first stage is to mark out the slot. The last stage is to accurately level off the bottom of the slot.

Select the correct intermediate stages.

A corner halving joint is shown . An important part of making any joint is marking out. There are four stages in the marking out process of this joint, select them.

Name this tool which can be set/adjusted to draw lines at a range of angles to an edge.

Name this tool used to mark/cut across the grain of the timber or mark wood before sawing/cutting.

The blank shown has to be prepared for the turning process before it is mounted on the woodturning lathe to be turned into a bowl.

which stage would come first?

Select the tool shown in the image.

Select the tool shown in the image.

Select the tool shown in the image.

Select the tool shown in the image.

Select the tool shown in the image.

Select the tool shown in the image.

Select the tool shown in the image.

Select the tool shown in the image.

A mortise gauge is shown, select from the options below the part labelled A in the diagram.

A mortise gauge is shown, select from the options below the part labelled B in the diagram.

Vee-notches are cut using a marking knife and chisel, before sawing. Select a reason why vee-notches are cut before sawing.

If the mortise is 3/5 the depth of the final width of the material, how wide is the material?

The blank is turned to 30 mm diameter.

Name the measuring tool which is used, along with a steel rule, to check this diameter.