WorksheetsFUN 101 Week 9
Total questions: 10
Worksheet time: 7mins
Tech A says: in order to make a threaded hole for a bolt... You have to drill the hole bigger than the bolt. Tech B says: In order to make a threaded hole for a bolt... You must use a die and the die must be the same size as the bolt. Who is correct?
Tech A
Tech B
Both Tech A and B
Neither Tech A nor B
Whats the name of the tool used to loosen or tighten the drill around a bit.?
Key
Chuck
Rabbit
Beaver
Toothed Handle
If your Tap is 3/8 of an inch.... What size drill bit should be used to make the hole?
3/8"
5/16"
9/32"
7/16"
11/16"
Your drill bit is .6875".... What Tap would work to make a threaded hole for a bolt?
5/8"
1/2"
7/8"
3/4"
9/16"
Match the following
Die Wrench
Needs a Chuck
Doesn't need a Chuck
Tap Wrench
Just Chuck
Tech A says: When using a Die... The side with the numbers should be facing outward after installing it in the Die Wrench. Tech B says: The Die should be the same size as the bolt being cut. Who is correct?
Tech A
Tech B
Both Tech A and B
Neither Tech A nor B
What is the decimal equivalent of 3/16" ?
.1875
.3125
.3750
.1250
.0625
What is the fraction equivalent of .5625" ?
1/2
7/16
3/8
9/16
5/16
Match the following
Drill Press
Hydraulic Press
Bench Press
Bench Vise
Panini Press
Tech A says: when drilling in metal its best to use the drill at full speed. Tech B says: Even if the drill bit is cutting into the metal, its best to use some lubrication to prevent the bit from overheating. Who is Correct?
