The clothes you wear are very important to your safety. Loose clothes, shirts, or blouses that aren't tucked in, sleeves that aren't buttoned or rolled up, are dangerous because they

The right shoes are important too. They can protect you from an electrical shock, from falling tools or falling parts, and from slipping. When you're in the shop area you should wear

To avoid serious injury, long hair must be worn under a cap or tied back. This is so the hair won't get

Some of the equipment may look simple to use, but it may not be so easy to figure out what could go wrong. Don't use any equipment until

Don't use any equipment unless the instructor is in the shop. Before you use any equipment, whether it's during class or after class, you must have

There are several reasons it's important to use the right tool and the right size tool for the job. The most important reason is

When you carry a tool with a sharp point or a sharp edge, carry it so no one gets hurt if you trip or bump into someone. The correct way to carry a sharp tool is with the point or edge

When you hand someone a tool, lay it down so they can pick it up by the handle, or hold it so they can

Tools should never be put in your pockets because they could

A worn or defective tool is more dangerous to use than a sharp tool or one that's in good condition. Defective tools should be

The work area must be kept cleared and clean. This isn't just for neatness, but for everyone's safety too. So they won't get in the way, bumped into or tripped over, tools that you have finished with should be

Don't lay tools on ledges, ladders, or any place where they could

Tools that are left sticking out over the edge of a bench or a machine are dangerous because

Paint thinner should be stored in a

When you're using power equipment with safety guards, be sure the guards are in place. Whenever you use power equipment such as saws, or sanders; wherever there is a possibility of eye injury you should always use

The person using equipment has the control of the machine; no one else should operate it with them. If someone is using a machine

If you are using a machine and have to leave it for any reason

If a piece of equipment doesn't work right, if it doesn't sound right, or it you can see that something is wrong with it

When lifting somethin from the floor, use the muscles in your

Some tools such as hammers have surfaces that have been tempered. This means they have been hardened so they won't bend, dent, or break easily. Never strike a hardened surface with a hardened tool because

Yanking on a cord to disconnect an electrical plug may loosen the terminals in the plug and cause a short or a fire. The correct way to disconnect a power line is to

Don't fool around int he shop area. Running, shoving, and any other horseplay in the shop area

When working with laser equipment you should

Accidents are most commonly caused by

To reduce the accident rate, carpenters should

The safe ratio for using an extension ladder would be

In the event of a Code Red, we

In the event of a classroom emergency, the first thing we do is

When you complete any test involving safety, you must achieve what score to pass?

A Class "A" fire is caused by

A class "B" fire is caused by

A class "C" fire is caused by

The first aid kit is located in

When putting out a fire, you

The shop fire extinguishers are equipped to put out

Someone else's carelessness could cause an injury to you and your carelessness could cause injury to someone else. Because of this, preventing accidents is