It is a unit of measure of electric current

It is a wire through which current flows

It is the quality of electric current measured in ohms that resist the flow of current

A unit of power

It is the path of electric current from the source to the components and goes back to the source

A material used to cover electric wires which may be made from plastic,

rubber, or asbestos.

A wire or a cord which provides path for current flow

Accessories that are used to connect from boxes to conduits or raceways to the other boxes in the electrical system

These tools are made of steel hardened and tempered at the tip used to loosen or tighten screws with slotted heads. They come in various sizes and shapes.

These are tools used in driving or pounding and pulling out nails. They are made of hard steel, wood, plastic or rubber.

The blade tip is wedge-shaped and resembles a negative (-) sign. This is used to drive screws with a single slot head.

This has a cross tip resembling a positive (+) sign. This is used to drive screws with cross slot heads.

Used to turn screws in tight space where standard screw driver cannot be used.

What type of hammer is this?

What type of hammer is this?

What type of hammer is this?

This is used for gripping, holding, and cutting electrical wires and cables and even small nails. They are usually used by linemen in doing heavy tasks.

This is used for cutting and holding fine wires. This can reach tight space or small opening where other pliers cannot reach and also used in making terminal loops of copper wires

A tool used for removing insulation of medium-sized wires ranging from gauge #10 to gauge #16.

This is used by linemen to remove insulation of wire and cables in low and high voltage transmission lines.

It is used in making holes on metal sheets and concrete walls.

This tool is used to cut metal conduit and armored cable

Electricity can pass through in a water

Ten (10) Watts is equivalent to 1 kilowatt

A circuit protective device that

automatically blows and cut the current

when and over load or short circuit

happens.

Is a duplex stranded wire used

for temporary wiring installation and

commonly used in extension cord

assembly.

Junction box and utility boxes are usually made of PVC. PVC stands for ________

Electrical materials used to hold and anchor electrical conduits in its proper position.

A device inserted to a convenience outlet to conduct electric current. A flat cord is attached to it on one end and the other end is connected to a current consuming instrument or appliance.

What is the measurement?

What is the measurement?

What symbol is this?

What symbol is this?

What symbol is this?

Part of a multi-tester

What is this?

What is this?

A _________ is necessary before undertaking any project because it serves as your guide in accomplishing an activity. It will give you an idea what needs to be done, how much to spend and what procedures to undertake.

A wire is made of a single strand of copper or aluminum wire. These are used in wiring installation inside and outside the buildings.

Has the sole authority to seal electrical plans among others

Can install, wire, operate, maintain and repair electrical machinery, equipment, and devices in residential, commercial, institutional, commercial, and industrial buildings, in power plants, substations, watercraft, electric locomotives, etc.

Supervises operation and maintenance of electrical equipment in power plants, industrial plants, watercraft, electric locomotive, etc.

In the Philippines, the Professional Regulation Commission conducts examinations to give licenses to electricians in adherence to which Republic Act?

If the work exceeds ________ volts, it must be supervised by a PEE or REE.

It is a sketch of electrical circuit that shows the external appearance of each component. It is much like a photograph of the circuit and uses simple images of parts.

It is a sketch showing the components of the circuit using standard electrical symbols.

It is a circuit in which lamps are arranged in a chain, so that the current has only one path to take.

It is a circuit in which lamps are connected across the wires. The voltage across each load on parallel circuit is the same.

In an electrical plan, you saw S3 in a switch symbol. What does S3 signifies?