WorksheetsSafety test review
Total questions: 10
Worksheet time: 5mins
How many o-rings are required on the cone end of an oxyacetylene torch handle?
1
2
3
4
After lifting a vehicle about a foot in the air what should be done?
Give it a shake
Check the mileage
Check tire pressure
Lower it and re-check hoist arm placement
In the event of a flash back what should be turned off first?
Oxygen
Acetylene
When is it not advised to use gloves?
Using a bench grinder
Using a spring compressor
Using the tire machine
Performing an oil change
When is the best time to consult an MSDS sheet?
After using a product
Before using a product
After an injury has occured
When directed to by your boss
Which statement below regarding airborne asbestos is correct?
HEPA filter vacuums are not sufficient to prevent airborne asbestos contamination.
The OHSA requires that asbestos materials be "wetted" to prevent airborne particles.
It is easy to tell which friction materials will produce asbestos dust.
Large and small asbestos particles must all be disposed of as hazardous waste.
Why is it recommended to purge the lines before lighting an oxyacetylene torch?
To clear any potential mixed gas
To ensure an accurate flame is achieved
To reduce pressure in the lines
To check regulator operation
The process of combustion occurring without an open flame is called ________.
cold fusion
direct ignition
spontaneous combustion
non-flame combustion
The following chemicals are all considered hazardous waste EXCEPT.
Cleaning solvent that has spilled onto the floor in the shop
Used ether-based cleaning solvents
Old containers used to store used cleaning solvent
New antifreeze
What does this symbol mean?
Oxidizing gas
Fire hazard
Spicy donuts
Explosion hazard
