Font size
WorksheetsDremel 3D Units 4 and 5
Total questions: 13
Worksheet time: 7mins
What is the name of Dremel's cloud-based slicing software and operating system mentioned in the video?
Simplify3D
Cura
3D Printer OS
Tinkercad
What are the buttons mentioned in the 3D Printer OS software?
Repair, Slice, Print, Upload
Rotate, Scale, Print, Repair
Upload, Edit, Print, Scale
Repair, Layout, Slice, Print
What is the purpose of the 'Repair' button in the 3D Printer OS software?
To repair and rotate the file
To upload a file
To select the type of support
To change the layer height
What can be adjusted in the 'Layout' step of the 3D Printer OS software?
Support type
Rotation and scaling
Infill density
Layer height
What does the 'Slice' step in the 3D Printer OS software allow you to do?
View the project
Check the temperature
Select the layer height
Choose the support type
What does the infill density setting in the slicing software refer to?
The speed of the print
The type of support used
The percentage of fill on the inside of the print
The thickness of each layer
What can cause the issue of 'spaghetti' in a 3D print?
Model was saved with minimal surface area contacting the build plate
Object was built floating above the build platform with no support selected.
Clogged extruder
Filament running out
What should be done if the extruder gets clogged?
Change the filament
Level the build plate
Adjust the print settings
Stop the job and purge out the old filament
What are two possible solutions if the layers of a print are not sticking properly?
Increase the infill density
Use a different filament
Level the build plate
Make sure there is glue on the build plate
What is an important factor to do before each time you build?
Level the build plate
Never use support
Adjust the layer height
Change the safety settings
If a model fails to completely build, what are two possible/likely causes?
Printer ran out of material
The printer is too level
Filament clogged during build
You are using a 3D file instead of a 2D file
Multiple models can be printed on a single build plate
True
False
If the 3D40 is not adhering (sticking) to the buildplate, what should you do?
Add more glue
Check and replace the blue/black tape
Tilt the build plate
Increase the temperature
