Connecting two lengths of conductor, to join ropes or wires by weaving or twisting them together.

Removing the insulation of connecting wires.

A pocket-sized tool used to test the presence of current in a line wire or Circuit

Used to measure the current flowing in a conductor. It is clamped or hanged in a conductor.

It is an electrical device that measures voltage, current, and resistance.

It is an electronic device that measures resistance in an electronic component or circuit.

An instrument used for measuring the potential difference or voltage between two points in an electrical circuit.

Is an instrument used to measure the flow of electric current in a circuit.

This used for removing burrs in conduits.

This is a special flexible steel wire used for pulling the conductors in conduits.

A blank punched out of a piece of sheet metal. Conduit- a pipe or tube

This used for removing burrs of newly cut conduits. It is available in different sizes.

This is a slotted circular disk used to find the diameter or size of an electrical wire.

Used to measure the length of an object in centimeters and inches. This is also used to measure heights for switches and outlets.

Used to measure length, width, and thickness of short flat objects and to draw straight lines.

This is used to measure the diameter and thickness of cables, wires, or conductors.

This is used to solder connecting wires

This is used for removing soldered wires.

Is a place where the soldering iron is placed during usage.

This is a wire-like boring tool used in making initial holes for split knob screws.

A small drilling machine with a chuck capacity of ¼ to 3/8 inch. It is used in making holes on metal sheets and concrete walls.

A device designed to open and close a circuit by non-automatic means and to open the circuit automatically on predetermined overload of current without injury to itself when properly applied within its rating.

A conducting connection whether intentional or accidental between an electrical circuit or equipment and earth, or to some conducting body which serves in place of the earth.

a point on the wiring system at which current is taken to supply utilization equipment.

It includes buses, with or without switches and/or automatic over current protective devices for the control of light, heat or power circuits of small individual as well as aggregate capacity.

Charges can move through any of several paths.

a circuit in which all parts are connected end to end to provide a single path for current.

The movement of charged particles in a wire to a specific direction. The charged particles may be a positive ion or a negative ion.

It is the electric pressure that causes current to flow.

Is the opposition to the flow of charge.

Is a welding technique in which a flux covered electrode helps create a welded joint

Works well in _____ and rainy conditions.

___________, equipment is inexpensive.

No external shielding gas is required since the ____provides the protective gaseous layer - this makes stick welding cost- effective.

Compared to other welding techniques, stick welding is_____severely affected by dirt, corrosion and paint - this can save pre-welding cleaning time.

You can change ___ easily for various metals.

You can attach the ground ____ at a considerable distance from the welding area.

This kind of joint is commonly used to join two or more conductors inside the junction box.

This method of wrapping is generally used on small cables because the strands are flexible, and all can be wrapped in one operation.

This is a two-tap wire turned simultaneously and is used where the two-tap wire is under heavy tensile stress.

This is the most widely used splice or joint in interior wiring installation to extend the length of wire from one point to another.

This is used extensively for outside wiring to extend the length of wire from one end to another.

This is used on large solid conductors where it is difficult to wrap the heavy tap wire around the main wire.