Font size
WorksheetsCisco 2, Module 5
Total questions: 14
Worksheet time: 21mins
Which two concepts relate to a switch port that is intended to have only end devices attached and intended never to be used to connect to another switch? (Choose two.)
PortFast
bridge ID
extended system ID
edge port
PVST+
Which three port states are used by Rapid PVST+? (Choose three.)
forwarding
learning
discarding
blocking
trunking
Which two statements describe a switch port that is configured with PortFast? (Choose two.)
The switch port should never receive BPDUs.
The switch port immediately transitions from blocking to the forwarding state.
The switch port immediately processes any BPDUs before transitioning to the forwarding state.
The switch port sends DHCP requests before transitioning to the forwarding state.
The switch port immediately transitions from the listening to the forwarding state.
What is one way to correct a spanning tree failure?
Replace all instances of STP with RSTP.
Manually remove redundant links in the switched network.
Replace the cables on failed STP links.
Insert redundant links to replace the failed STP links.
When PVST is running over a switched network, which port state can participate in BPDU frame forwarding based on BPDUs received, but does not forward data frames?
forwarding
listening
blocking
disabled
An administrator is troubleshooting a switch and wants to verify if it is a root bridge. What command can be used to do this?
show running-config
show spanning-tree
show vlan
show startup-config
Which port state will switch ports immediately transition to when configured for PortFast?
learning
forwarding
listening
blocking
During the implementation of Spanning Tree Protocol, all switches are rebooted by the network administrator. What is the first step of the spanning-tree election process?
All the switches send out BPDUs advertising themselves as the root bridge.
Each switch with a lower root ID than its neighbor will not send BPDUs.
Each switch determines the best path to forward traffic.
Each switch determines what port to block to prevent a loop from occurring.
Which is the default STP operation mode on Cisco Catalyst switches?
RSTP
Rapid PVST+
PVST+
MST
MSTP
Which STP port role is adopted by a switch port if there is no other port with a lower cost to the root bridge?
disabled port
root port
designated port
alternate
What additional information is contained in the 12-bit extended system ID of a BPDU?
IP address
port ID
VLAN ID
MAC address
What value determines the root bridge when all switches connected by trunk links have default STP configurations?
MAC address
VLAN ID
extended system ID
bridge priority
After the election of the root bridge has been completed, how will switches find the best paths to the root bridge?
Each switch will analyze the BID of all neighbors to reach the root and use the path through the lowest BID neighbors.
Each switch will analyze the port states of all neighbors and use the designated ports to forward traffic to the root.
Each switch will analyze the sum of the hops to reach the root and use the path with the fewest hops.
Each switch will analyze the sum of all port costs to reach the root and use the path with the lowest cost.
What is an accurate description of redundancy?
designing a network to use multiple virtual devices to ensure that all traffic uses the best path through the internetwork
configuring a router with a complete MAC address database to ensure that all frames can be forwarded to the correct destination
configuring a switch with proper security to ensure that all traffic forwarded through an interface is filtered
designing a network to use multiple paths between switches to ensure there is no single point of failure
