Font size
WorksheetsHigh on Electrified wheels
Total questions: 15
Worksheet time: 6mins
1.The aerodynamic forces acting on the car are
Drag force
Lift force
Down force
All the above
2.what are the loads needed to design the shaft?
bending load
Torsional load
compression load
Tensile load
3.which type of drive is used in F1 cars?
FWD
RWD
4WD
AWD
4.which type of chassis is used in a formula bharat car?
Monocoque
backbone
Ladder
Tubular
5.In which test analysis the failure point in chassis can be known ?
Roll over analysis
fatigue test
Torsional rigidity test
Impact test
6.Brushed DC motor has which type of commutation
Mechanical commutation
Electronics Commutation
Electrical commutation
7.Brushless DC motor has which type of commutation
Mechanical commutation
Electronics Commutation
Electrical Commutation
8.what is our pedal ratio?
1:6
1:5
5:1
6:1
9.what type of braking system does heavy vehicles use?
mechanical braking
pneumatic braking
hydraulic braking
all the above
10.which set of wheel locking is better?
front wheels
rear wheels
all wheels
one front and one rear
11.Which component of the steering system connects tie rod and wheels?
pinion
rod end
knuckle
upright
12.Operating angle for UV joint is
140
132
135
145
13.The order in which effort applied to the steering wheel is transferred to the front wheel is
Steering wheel, rack and pinion, steering shaft, tie rod, steering knuckle, front wheels
Steering wheel, steering shaft, rack and pinion, tie rod, steering knuckle. front wheels
Steering wheel, steering shafi,rack and pinion, steering knuckle, tie rod, front wheels
Steering wheel, tie rod, rack and pinion, steering shall, steering knuckle, front wheels
14.How is the mechanical energy from the spring dissipated ?
thorugh the bounce back of spring
as heat through dampers via orifices
as heat through dampers via springs
as heat through dampers via torsion action
15.Choose all the TRUE statement(s)
The upper and lower control arm axis meet at the instantaneous center
the CG must be as close to the ground as possible
Mcpherson strut always requires both the control arms
The upper and lower control arm axis, both must meet at the CG
