NEW
Font size
Worksheetsbody questions
Total questions: 10
Worksheet time: 5mins
Which of the following is NOT a method manufactures' us to construct walls on RV's
bonded sidewall
semi-bonded
aluminum tube frame
extruded Styrofoam
When preforming a repair to an RV, knowing the type of construction in an RV is extremely important to
estimate material and labor required for repair
select to use lock joints or joiner rails
make quick and inexpensive repairs
measuring the length of the EPDM
When inspecting exterior moldings, seals and roofs, look for
voids, gaps, and cracks
staining
dirt
data of manufacture
When installing aluminum siding below the starter piece, one edge is attached using an interlock flange and one edge is
fastened on the top
not fastened
fastened on the bottom
seam sealed at both ends
In a collision where frame damage is sustained, a vehicle with a steel frame is more likely to transmit damage to other areas then a vehicle with a _____ frame which absorbs most the impact
wood
fiberglass
filon
aluminum
The temporary appearance of a grid on a laminated sidewall is caused by
a defect in the sidewall construction
faulty adhesion between layers
poor final finish on the sidewall surface
normal moisture and temperature change
A large bubble in a laminated sidewall is an indication of
too much direct sunlight
stress due to improper load distribution
excess interior air pressure
water leaks causing structural delamination
The following types of fiberglass panel damage require two-sided repairs EXCEPT
cracks or fractures
tears or rips
deep gouges
small holes or punctures
When repairing laminated body panels, always
use glue recommended by adhesive manufacture
use only OEM supplied adhesive
use only adhesives that have been tested to be compatible with all of the materials
use a different adhesive and solvent for each panel in the laminated assembly
A gel coated finish should always be
replaced with new gelcoat
completely removed before refinishing
relocated and then painted with urethane paint materials
free of oxidation or contaminates before refinishing
