WorksheetsITN - Module 17 - Build A Small Network
Total questions: 15
Worksheet time: 8mins
Which network design consideration would be more important to a large corporation than to a small business?
Internet router
Low port density switch
Scalability
Firewall
Redundancy
What common protocols support applications and services used by users in a small network? (Choose all that apply)
SMTP
FTP
HTTP
DHCP
DNS
Which software installed on key hosts can reveal the types of network traffic flowing through the network?
MacOS
Wireshark
SSH
Windows
Linux
A technician has established a remote connection to router R1 to observe debug output. The technician enters the debug ip icmp command then pings a remote destination. However, no output is displayed. Which command would the technician have to enter to display log messages on a remote connection?
monitor debug output
monitor terminal
terminal monitor
terminal monitor debug
access monitor
A technician is troubleshooting a network problem and has just established a theory of probable causes. What would be the next step in the troubleshooting process?
Test the theory to determine cause
Verify solution and implement preventive measures
Identify the problem
Document findings, actions and outcomes
Establish a plan of action and implement th solution
You as an administrator are testing connectivity to a server. After the ping command was initiated the reply comes back as time expired. What indicator represent the reply?
U
!
M
.
Q
A technician enters the tracert -6 command on a windows host PC. What is the purpose of the -6 command option?
It only allows 6 hop counts
It forces the trace to use IPv6
Stops the tracert using IPv6
It sends 6 probes within each TTL time period
Forces only 6 replies at each hop
A network technician is investigating network connectivity from a PC to a remote host with the address 10.10.10.15. Which command, when issued on a Windows PC, will display the path to the remote host?
traceroute 10.10.10.15
trace 10.10.10.15
tracert 10.10.10.15
ping 10.10.10.15
When should an administrator establish a network baseline?
At regular intervals over a period of time
At the lowest point of traffic in the network
When the traffic is at peak in the network
When there is a sudden drop in traffic
Which statement is true about CDP on a Cisco device?
The show cdp neighbor detail command will reveal the IP address of a neighbor only it there is Layer 3 connectivity
To disable CDP globally, the no cdp enable command in interface config mode must be used
Because it runs at the data link layer, the CDP protocol can only be implemented in switches
CDP can be disabled globally or on a specific interface
A network engineer is troubleshooting connectivity issues among interconnected Cisco routers and switches. Which command should the engineer use to find the IP address information, host name, and IOS version of neighboring network devices?
On which two interfaces or ports can security be improved by configuring executive timeouts? (Choose two)
VTY port
Console port
You are troubleshooting an issue and need to verify the IP addresses of all interfaces on a router. What is the best command to use to accomplish the task?
show ip route
Users who are connected to the same switch are having problems, having slower than normal response times. You as the administrator suspect a duplex issue. What is the best command to use to accomplish the task?
A support technician needs to know the IP address of the wireless MAC. What command is best to use on a specific interface?
ipsettings en0
netconfig en0
ifconfig getifaddr en0
macconfig en0
show interface en0
