NEW
Font size
WorksheetsProgression revision 2
Total questions: 20
Worksheet time: 10mins
What test pressure should above ground drainage be tested at?
20mm
30mm
38mm
48mm
Likelihood, severity and control measures should be considered when writing what?
An invoice
Accident report
Risk assessment
Job record
What type of fitting is shown?
Pressure/temperature relief valve
Double check valve
Stop valve
Blending valve
What fluid category is wholesome water?
1
2
3
5
What guttering profile is shown in the image?
Deep flow
Ogee
Square
Half round
Which building regulation covers notching and drilling of joists?
Part A
Part B
Part C
Part D
Which above ground drainage system is shown in the image?
Primary ventilated stack
Secondary ventilated stack
Ventilated discharge branch stack
Stub stack
What colour skip is used for scrap wood?
Red
Yellow
Blue
Green
What effects does adding additional wheels to a pully system make?
The effort needed to lift the weight is reduced
The effort needed to lift the weight is increased
Put more strain on the object
Put less strain on the object
What fitting is shown below?
Compression tee
Compression tank connector
Compression socket
Compression tap connector
Which system would you a 3 port motorised valve be fitted to?
Y plan
C plan
S plan
P plan
What power tool would you use to drill through a concrete wall?
SDS drill (slotted drill system)
Combi drill
Percussion drill
Drill driver
What is the potential risk to a bare copper pipe passing through a concrete wall?
Damage from corrosion
Damage from pipe movement
Damage from wall movement
No risk at all
Which one of the following would be carried out during the first fix stage?
Installation of the combination boiler
Carcassing the bathroom
Installation of internal doors
Painting
Which one of the following could prevent water hammer in a plumbing system?
Installation of a boosted cold water system
Replace the current installation to a direct cold water system
Make sure all pipework has been clipped correctly
Turn off all service valves
Kelvin is a unit of measurement for:
Length
Time
Temperature
Weight
Under the Health & Safety at Work Act an employer must produce a written health and safety policy statement when employing:
1 operatives
5 operatives
3 operatives
4 operatives
Which of the following electrical power tools is the safest to use on a construction site?
415V tool
240V tool
110V tool
Cordless tool
During electrolytic action, which one of the following would occur?
Anode will gradually destroy the cathode
Electrolyte will destroy the cathode
Electrolyte will destroy the anode
Cathode will gradually destroy the anode
What is the main function of the clerk of works on site?
To coordinate the different trades
To maintain the project within budgetary constraints
To assure the quality of workmanship on behalf of the architect
To check health and safety standards are legal
