NEW
Font size
Worksheetspower tools
Total questions: 20
Worksheet time: 30mins
when using a circular saw, be sure to cut on the waste side of the mark to allow for the blades.
arbor
kerf
distoration
stroke
When using a portable band saw, make sure that the stop is placed firmly against the
object being cut
trigger lock
bench surface
miter box fence
Saw that fine blades that are excellent for delicate and intricate cutting are called.
band saws
saber saws
abrasive saws
worm-drive saws.
Never use a circular saw that does not have an upper blade guard because the
trigger lock will not work properly.
saw will not cut cleanly.
guard protects you from touching the blade.
saw kerf will be too wide.
A power tool that is well suited for breaking up concrete during demolition work is a(n)
saber saw
impact wrench
pavement breaker
powder actuator
A pneumatic drill is commonly used.
in areas where noise is problem
to supply compressed air to de-burr pipes
when there is no source of electricity
for intricate detail work
A grinder can catch on rough material edges and shift around, especially when using rotary bits called?
Burr bits
Backing bits
Kerf bits
Saber bits
Before using a pneumatically powered nailer for the first time, it is important to:
Disassemble the nailer for inspection
Load the nails into the nailer
Ensure that a GFCI is in the power supply
Read the manufacturer's instructions
When using power tools, never engage the
locking spring
booster
bit shank
trigger lock
Before replacing parts such as bits, blades, or discs on any tool, you must___.
polish it with a fine steel wool
recharge the tool's battery
disconnect the power source
inspect them for cracks
A lot-velocity Fastening system that is used to drive steel pins or threaded studs into masonry and steel is a(n).
Pneumatic screw nailer
Powder-actuated tool
air impact wrench
mini hammer drill
The part of a drill that holds the drill bits in place is called the.
Auger
Chuck
Shank
Ram
A power miter saw combines a miter box with a
bandsaw
circular saw
reciprocating saw
Saber saw
A good way to check the condition of the grinding wheel on a bench grinder is to
Exceed the maximum rpm rating
Hold the tool rest against the wheel
Induce vibration and monitor the wheel's response
Perform a ring test on the wheel
Special training and certification is required before using any kind of powder-actuated fastening tool.
powder-actuated fastening tool
electrically powered tool
pneumatic nail or screw system
Hydraulic lift or press tool
Before you plug any saw into a power source, make sure the
speed is set to low
power switch is in the OFF position
work has been clamped down
lower blade guard is pulled back
An angle grinder is used to grind
soft, porous material
imperfection in wood
hard, heavy materials
nonmetals only
If a pneumatic nailer is not firing properly, before attempting repairs be sure to
adjust the compressor
disconnect the air hose
adjust the regulator
remove the booster
the adjustable tool rest on a bench grinder should be positioned
1/8 inch from the grinding wheel
1/4 inch from the upper wheel guard
1/2 inch from the lower guard
3/4 inch from the wheel arbor
most hammer drill will not hammer until pressure is
released from the powder charge
reached in the hydraulic cylinder
detected at thr trigger lock
applied to the drill bit
