wayground logo

Free Printable Worksheets

NEW

Font size

S
M
L
XL
Worksheets

Transmission Replacement Quiz

Total questions: 10

Worksheet time: 5mins

Name
Class
Date
1.

What is one of the reasons you might need to remove a transmission?

a)

To replace the clutch

b)

To change the oil filter

c)

To install a new stereo system

d)

To upgrade the headlights

2.

What could be an indication of a bad rear main seal?

a)

Oil leak at the rear of the engine

b)

Coolant leak from the radiator

c)

Exhaust leak from the muffler

d)

Brake fluid leak from the brake lines

3.

What is the purpose of using a universal joint extension when removing the transmission?

a)

To lift the car higher

b)

To reach hard-to-reach bolts

c)

To tighten the lug nuts

d)

To drain the transmission fluid

4.

Why is it important to support the engine when removing the transmission?

a)

To increase the engine power

b)

To make the car lighter

c)

To improve fuel efficiency

d)

To prevent unwanted stress on the motor mounts

5.

What should be done before lowering the transmission jack?

a)

Install the two bolts holding in the transmission mounts

b)

Remove the exhaust system

c)

Drain the transmission fluid

d)

Disconnect the battery cable

6.

What is the recommended torque for tightening the starter bolts?

a)

80 foot-pounds

b)

50 foot-pounds

c)

30 foot-pounds

d)

18 foot-pounds

7.

How should the transmission fluid be filled after installation?

a)

Through the radiator cap

b)

Through the hole where the shifter goes

c)

Through the exhaust pipe

d)

Through the tailpipe

8.

What is the purpose of breaking in the new transmission for the first 500 miles?

a)

To save fuel consumption

b)

To allow the parts to properly seat and wear in

c)

To test the maximum speed of the car

d)

To perform burnouts and hard shifts

9.

What should be done after installing the driveshaft?

a)

Tighten the bolts evenly to prevent leaks

b)

Remove the transmission fluid

c)

Disconnect the oxygen sensors

d)

Replace the spark plugs

10.

What is the purpose of using medium strength thread locker on the bolts?

a)

Prevent vibrations from loosening the bolts

b)

Reduce the engine noise

c)

Increase the weight of the car

d)

Improve the transmission performance