Wayground logo

Free Printable Worksheets

Font size

S
M
L
XL
Worksheets

Arduino

Total questions: 20

Worksheet time: 9mins

Name
Class
Date
1.

What do you call this component?

a)

Uno Cards

b)

Raspberry Pi

c)

Arduino Duo board

d)

Arduino Uno board

2.

What is an LED's negative leg called?

a)

Anode

b)

Cathode

c)

LED Chip

d)

Flat spot

3.

What do you call this component?

a)

Arduino Uno board

b)

Raspberry Pi

c)

Breadboard / Protoboard

d)

White Plastic Board

4.

Which command is called repetitively over and over again as long as the Arduino has power.

a)

loop ( )

b)

(output)

c)

setup ( )

d)

(input)

5.

What does this button represents?

a)

A. Verify

b)

B. Check

c)

C. Integrate

d)

D. Upload

6.

What does LED stand for in electronics?

a)

Light Emitting Diode

b)

Long Electrical Diode

c)

Low Energy Device

d)

Light Emitting Device

7.

What do you call this component?

a)

capacitor

b)

transistor

c)

diode

d)

resistor

8.

What is an LED's positive leg called?

a)

Anode

b)

Cathode

c)

LED Chip

d)

Flat spot

9.

What is the correct syntax for setting up an LED as an output in Arduino?

a)

pinMode (LED, OUTPUT);

b)

pinMode (OUTPUT, LED);

c)

pinMode (LED, INPUT);

d)

pinMode (INPUT, LED);

10.

What does the following line of code do in Arduino?

digitalWrite (LED, HIGH);

a)

Turns the LED on

b)

Turns the LED off

c)

Sets the LED to input mode

d)

Reads the input value from the LED pin

11.

Arduino is an open-source electronics platform based on easy-to-use hardware and software.

a)

True

b)

False

12.

Arduino programming is done using C++ language.

a)

True

b)

False

13.

The breadboard is a component used for soldering components together in Arduino circuits.

a)

True

b)

False

14.

Resistors are used to limit the amount of current flowing through components in an Arduino circuit.

a)

True

b)

False

15.

As the delay time increases, the LED blinks faster.

a)

True

b)

False

16.

What is the other term for Arduino code?

(a)  

17.

These part of the breadboard are mainly used for power supply connections.

(a)  

18.

This part of the breadboard is mainly used for electrical components.

(a)  

19.

Which of the following steps must be done right after typing the code?

a)

Save the code

b)

Upload the code

c)

Change the port

d)

Verifty the code

20.

Which of the following steps must be done right after connecting the USB cable and Arduino board?

a)

Save the code

b)

Upload the code

c)

Change the port

d)

Verifty the code