Font size
WorksheetsSafety Refresher
Total questions: 25
Worksheet time: 21mins
1/8"-1/4"
1"
If you are about to make a cut that would put your fingers within 2-3 inches of the bade.... you need what tool to keep your fingers away from the blade?
PUSHSTICK!!!!
pulltwig
pokebutton
What is the purpose of a push stick?
to cut through and test if the blade is sharp
to keep control of your stock while getting your fingers to the sides of the blade.
To pull your hand backwards but still in front of the blade.
Curves
While cutting a curve, your hands may move from a safe place to a danger zone... what should you do?
Start pulling the stock from behind
Keep moving in the same direction but go slower
Move your fingers to a better place away from the blade
Talk to your friend while making the cut, they always have good advice
Check to see if all of the guards are in 1/8-1/4" above wood
Ask yourself if you are safe and could this cut be safer?
Why do we rotate the drill bit in the chuck?
So you can see if the drill bit is straight in the chuck or bent.
So you can tighten it in the chuck
So you can see if the drill bit has been tightened properly
Where should you never leave this chuck key?
On the table
In your pocket
In the drill chuck
You ALWAYS have to secure your stock to the table or in a vise when drilling it.
True
False
Drill Chuck
Hand Feed
Table lock
Depth Stop
Most of this vise is pointing to the left...
Nice fun fact, but it is probably just luck
That's dangerous, it could spin into the operator
Good, if the drill bit gets stuck it won't hurt the operator
Before drilling through your stock you need to:
Set the Depth Stop to stop before it cuts through the stock.
Check to see if the bit will go through the stock and what it might drill in to.
Loosen the Table Clamp and adjust the work table so it is 1 foot below the chuck.
Select ALL personal protection equipment (PPE)
that is required to work with a drill press?
Safety Glasses
Closed Toe Shoes
No Baggy Clothes
Hair/Jewelry Restrained
Leather Gloves
Before using the Sander, you should:
A. Ask your instructor’s permission
B. Remove all Jewelry, eliminate loose clothing, & confine long hair
C. Wear approved, sanitized safety glasses.
D. All of the above
Before you start sanding, you should check material for foreign ________________.
Languages
Objects
Invaders
Countries
Before sanding you should check to make sure:
A. All tables are at the correct angle and secure
B. Make sure the the belt/disk are not loose, torn, or clogged up
C. Neither A nor B
D. Both A & B
Hold the material firmly on the ___________ while sanding.
Ground
Handle
Table
Stand
While the sanding is running, it is VERY IMPORTANT to keep fingers away from the belt/disk
True
False
Hold the material ____________________ the belt/disk before you turn on the Sander.
on
away from
against
gently
When finished, you should:
A. Turn off the Sander
B. Do the Sander dance
C. Wait for the Sander to come to a Complete Stop before cleaning
D. Both A & C
