NEW
Font size
WorksheetsDrill Press ID and Safety Quiz
Total questions: 15
Worksheet time: 8mins
What is the function of the 'Variable Speed Adjustor' in a Drill Press?
To adjust the height of the table
To change the speed of the drill
To lock the spindle in place
To switch the drill on or off
Which part of the Drill Press is used to hold the drill bit?
Spindle
Chuck
Hand Wheel
Column
What is the purpose of the 'Table Lock' on a Drill Press?
To secure the drill bit
To adjust the speed of the drill
To lock the table in a fixed position
To turn the machine on or off
What should you always do before using the drill press according to the safety rules?
Turn off the machine
Obtain permission from the instructor
Wear gloves
Start the drill press
According to the safety rules, what is essential to wear when operating the drill press?
Safety glasses
Ear protection
A helmet
A face mask
How far should your hands be kept from a moving brad point or twist drill according to the drill press safety rules?
At least 1 inch
At least 2 inches
At least 4 inches
At least 6 inches
What is the rule regarding the position of the work piece relative to the drill bit?
Keep the short side on the left
Keep the long side on the right
Keep the long side on the left
Position does not matter
What should be checked before starting the drill press to ensure the bit is ready for use?
The drill press is turned off
The bit is properly sharpened and securely fastened in the drill chuck
The drill press is at the highest speed
The work area is clean
What is the purpose of setting the depth stop on a drill press?
To prevent the machine from moving
To control the depth of the hole being drilled
To increase the drilling speed
To hold the workpiece in place
What should be done to prevent "burning" of the drill bit when drilling deep holes?
Drill faster
Use a smaller bit
Withdraw the bit frequently
Apply more pressure
How can one ensure safety when the drill press is operating?
Keep fingers close to the rotating bit
Remove the chuck key and wrenches before starting the machine
Operate without a belt guard
Ignore the depth stop
What is the recommended procedure for changing the drill bit on a drill press?
Turn off the power and wait for the drill to stop completely
Change the bit while the drill is running to save time
Ask another person to hold the chuck while changing the bit
Use gloves to hold the new bit while the machine is running
Why is it important to use a clamp or vise when operating a drill press?
To prevent the drill press from overheating
To keep the operator's hands free and safe
To increase the drilling speed
To enhance the precision of the drill bit
What should be done immediately after finishing work with the drill press?
Leave the machine running for the next user
Turn off the power and clean the area
Check the email for further instructions
Start another operation without assessment
How should you behave in the workshop to ensure safety?
Run to complete tasks quickly
Work quietly and pay attention to instructions
Work in pairs only
Listen to music through headphones to improve focus
