WorksheetsRCT Maintenance Training Quiz
Total questions: 25
Worksheet time: 23mins
What is the primary purpose of the ControlMaster® CM2200 remote control system?
To enhance machine speed
To improve safety and productivity
To reduce operational costs
To automate maintenance tasks
Which of the following is a prerequisite for attending the remote LOS control training course?
Completed LOS Operating procedures
Completion of a safety course
Must be at least 21 years old
Previous experience in mining
What does the term 'safe operating distance' refer to?
The distance from the operator to the machine where hazards are acceptable
The maximum distance a machine can operate remotely
The distance required for machine maintenance
The distance between two machines operating simultaneously
How often should the remote function test be conducted?
Every week
Every six months
Every two weeks or 250 Remote hours
Every month
What is the recommended action if the transmitter display flashes?
Check the writing on the display and make appropriate corrections
Ignore the warning
Continue operating the machine
Check the machine's oil levels
Which of the following is NOT a factor to consider when determining safe operating distance?
Proximity of safety zones
Machine articulation
Hydraulic oil temperature
Environmental conditions
What is the purpose of the ControlMaster® CM2200 Servicing System?
To provide operational checks and preventative maintenance
To train new operators
To automate machine functions
To reduce the need for manual checks
What should be done before operating the ControlMaster® CM2200 Remote Control system?
Conduct a visual inspection of the machine
Check the weather conditions
Ensure the operator is certified
Calibrate the machine settings
What should be done with the service report after completing maintenance?
Return it to the maintenance supervisor
Send it to the customer (Pieter)
File it in the main office
Discard it
Which of the following is NOT a type of service do by client maintenance technician mentioned in document?
Remote Fucntion Test
Remote Machine Service
OEM Remote Machine Service
OEM Transmitter/Receiver Service
What is the purpose of the continuity test on comms cables?
To check for voltage levels
To ensure proper communication
To measure resistance
To inspect for physical damage
What does the symbol 'v' indicate in the service form?
Not Applicable
Requires further inspection
Good, no defect found
Attention required
What method does the ControlMaster CM2200 receiver use to control the proportional functions?
PWM
Digital Devider
Relay
Potentiometer
What is the first step before starting service on the machine?
Ensure the machine is correctly isolated
Inspect the tires
Clean the machine
Check the oil levels
What should be checked during the visual inspection of the Remote?
Fuel levels
Corrosion, wear & tear, damage
Engine oil quality
Tire pressure
List the three methods that can be used to test the proportional outputs of the CM2200 receiver..
What are the two types of calibrations that are possible to be undertaken?
What are some of the common causes that may result in a disparity fault resulting in the machine shutting down?
Describe the remote LOS work flow?
[From Machine -> Remote System -> Back To Machine]
What does Figure No. 1 show?
Attachment Joystick
Implement Joystick
Steering Joystick
Blade Joystick
What does Figure No. 20 show?
Override
Engine Raise RPM
Camera Change
Engine Lower RPM
What does Figure No. 16 show?
Gear shifting
Gear upshift
Gear downshift
Ladder
What activities are shown in the picture?
Chris is configuring the receiver
Chris is updating the receiver firmware
Chris is troubleshooting
Chris was dizzy
What is Peter doing on the engine controller D155 according to the picture?
Open the cover
causing problems with the connector
Connect NE Sensor (27)
Connect Pedal Pos (9)
What is shown in the picture, except?
Receiver
Interface
POWER TRAIN CAN SIGNAL MODULE
STEERING CONTROLLER CAN SIGNAL MODULE
