WorksheetsPlaner Safety Test - Test #2
Total questions: 13
Worksheet time: 3hrs 50mins
Name
Class
Date
1.
Student Name (First, Last)
4 lines
2.
Class Period
4 lines
3.
When planning a board, first.......
a)
Adjust the machine for the correct thickness.
b)
Start the stock into the planer.
c)
Measure the thickness of the board at the thickest point.
d)
Turn on the power.
4.
Never try to remove more than ____ inch in thickness from a hardwood board during one pass.
a)
1/16"
b)
1/8"
c)
3/16"
d)
1/4"
5.
When planning any material, be sure to look for any ______________ prior to planning.
a)
Defects
b)
Foreign Materials
c)
Knots
d)
All of the Above
6.
Be sure you feed stock into the planer _________ the grain of the wood.
a)
Against
b)
With
7.
The shortest length of stock that may be run through the planner is?
a)
8"
b)
18"
c)
12"
d)
None of the above
8.
If two narrow boards are to be planed to the same thickness ............
a)
Run them through side by side.
b)
The planer must be adjusted twice.
c)
Run each piece through separately on the same depth.
d)
Use another machine, narrow boards should never be planed.
9.
The depth of cut may be changed between passes......
a)
While the board is going through.
b)
While the machine is running and no stock is being fed.
c)
At any time.
d)
When the machine is at a dead stop.
10.
The feed rollers can pinch and potentially break fingers for this reason you should always place your hands under the board to avoid injuring your fingers.
a)
True
b)
False
11.
It is _________ to look into the planer or to stand in line with the rotating head.
a)
Unsafe
b)
Safe
12.
To raise the elevation of the table, make ______ turns between cuts. (Maximum)
a)
1/4"
b)
1"
c)
3/4"
d)
1/2"
13.
Name the parts of the Planer
a)
Infeed Table
b)
Cutter Head
c)
Speed Control
d)
Height Adjustment
1
2
3
4
1)
2)
3)
4)
100 %
