WorksheetsSW 10 Week Assessment Review
Total questions: 25
Worksheet time: 13mins
The mnemonic device that we use to remember the elements of art is...
Sam can see the land from space
Sam can view the land from space
Sam can observe the land from space
Sam can reach the land from space
There are 2 categories of shape. What are they?
Non-organic & hard edged
Geometric & Circular
Organic & Geometric
Is Contrast an element of art or a principle of art?
Element of Art
Principle of Art
What element of art does the "V" stand for?
Value
Volume
Variety
A _______ is a mark that spans the distance between 2 points.
Line
Circle
Square
Triangle
A shape is flat, 2-dimensional and a form is 3 dimensional.
True
False
The act of shading a shape with a pencil creates what element of art?
Color
Value
Line
Space
The mnemonic device to remember the principles of art is BRUCE PM.
True
False
The distribution of visual weight in an object would be the definition of what principle of art?
Color
Space
Balance
Emphasis
When all of the elements of art are working together you would have what principle of art?
Movement
Unity
Contrast
Rhythm
The term focal point corresponds to what Principle of Art?
Contrast
Rhythm
Unity
Emphasis
How the surface of an object feels is the definition of what Art Element?
Line
Texture
Shape
Unity
There are two categories of Space.
True
False
The definition "a repetition of any of the elements of art" corresponds to what Principle of Art?
Movement
Line
Unity
Pattern
The following are all true regarding welding safety EXCEPT....
Eye wear must be worn during the welding process to prevent eye damage or eye sunburn.
Items on the floor are ok in the welding area as long as I am careful.
A cotton long sleeve shirt is important to prevent burns on my arms.
Jeans must be worn without frays or holes in them to prevent burns.
The first thing you do when you go into the welding area to weld is....
Turn the exhaust fan on.
Start your compressor.
Start welding.
I can throw away combustible items that may have fallen on the floor in a regular garbage can that is located anywhere in the room.
True
False
The correct industry term for metal inert gas welding is
SMAW
GMAW
GTAW
Round holes in the weld bead are a sign of porosity. Porosity is contamination in the bead.
True
False
In MIG welding the mix of gases used are argon and carbon dioxide. The percent of argon to carbon dioxide is
50/50% Argon/CO2
75/25 % Argon/CO2
25/75% CO2/Argon
60/40% Argon/CO2
To clean the metal before welding, what should you use?
use a flapper disc
use sandpaper
use a wire brush
All of the above
The plasma cutter is on, is grounded, but a yellow light indicates a malfunction somewhere. What problem exists?
Too much energy
Too high of an air pressure
Too low of an air pressure
Bad ground
Spatter on the weld means....
Metal was not clean
Arc is too long
Gas was not turned on
All of the above
MIG wire comes in many sizes. What is the recommendation for 12 gauge metal?
.035
.030
.045
.025
The home button on the welder allows you to....
Adjust the correct setting for the weld
Adjust your arc length
Set gas flow
Adjust wire speed
