Drawings that show natural and man-made features on the construction site are called _____.

Plan north on construction drawings typically points to _____.

An acute angle is an angle that is _____.

If two angles of a triangle are 34° and 42°, then the unknown angle equals _____.

To perform calculations, angle measurements expressed in degrees, minutes, and seconds can be converted to _____.

Potential safety problems that might occur while laying out a site can be identified by completing a(n) _____.

Fiberglass tape measures are typically more accurate than steel tape measures.

The most common lengths of steel tape measures are _____.

String used with a plumb bob is typically stored on a _____.

A typical brass plumb bob weighs _____.

The main difference between a builder’s level and a transit level is that the telescope with the builder’s level _____.

An electronic site layout instrument that can be controlled remotely is a(n) _____.

Vertical distances can be measured using a builder’s level and a _____.

Adding the backsight reading to the known elevation of a benchmark provides the _____.