NEW
Font size
WorksheetsS3 PWW - (Message Board) Marking Out
Total questions: 8
Worksheet time: 4mins
What is the primary use of a pencil in marking-out?
To engrave the workpiece
To mark lines and centers for cutting or joining
To measure materials for cutting
To scribe a double line parallel to an edge
How should a steel rule be used for accurate measurements?
Used to engrave the workpiece
Held at an angle
Flat against the side and bottom edges
Used with a sharp pencil
What is the function of a try square?
To scribe lines parallel to edges
To draw perpendicular lines on materials
To set an angle for cutting
To cut a line into wood parallel to an edge
Which tool is used to scribe a line parallel to an edge?
Cutting gauge
Mortise gauge
Marking gauge
Sliding bevel
What is the purpose of a cutting gauge?
To mark the bottom of a woodwork joint
To set an angle for cutting
To measure materials for cutting
To draw perpendicular lines
How is a mortise gauge different from a marking gauge?
It is used to set an angle for cutting
It is used to scribe a double line parallel to an edge
It is used to measure materials for cutting
It is used to draw perpendicular lines
What is the function of a sliding bevel?
To set an angle for cutting waste material
To engrave the workpiece
To scribe lines parallel to edges
To measure materials for cutting
What should be ensured when using a marking gauge?
The spur should dig into the material
The stock should be flat against the side of the workpiece
The tool should be held at an angle
The line should be engraved deeply
