Worksheets12 Transmission Questions
Total questions: 12
Worksheet time: 12mins
Name
Class
Date
1.
Which of the following components is NOT part of the clutch release mechanism?
a)
Clutch pedal
b)
Pressure plate
c)
Clutch cable
d)
Centre plate
2.
The purpose of the sliding joint fitted to a propeller shaft is to allow for:
a)
any torque fluctuations that occur in the transmission
b)
changes in the propeller shaft length due to movement
c)
the drive to be transmitted through a variable angle
d)
the drive to be transmitted at constant velocity
3.
A customer’s signature is required to authorise work being carried out on a vehicle because it:
a)
creates a legally binding contract
b)
is a requirement under the Supply of Goods and Services Act
c)
enables the garage to retain the car if a dispute occurs
d)
avoids liability for the garage
4.
What of type of gears are used in a sliding mesh gearbox?
a)
Helical gears
b)
Epicyclic gears
c)
Spur gears
d)
Hypoid gears
5.
Which of the following faults may produce clutch slip?
a)
Lack of free play
b)
Missing pedal rubbers
c)
Too much free play
d)
Lack of clutch fluid
6.
To safeguard yourself and others when working in a vehicle repair workshop you should:
a)
comply with all safety requirements
b)
be aware of others in your vicinity
c)
avoid any inappropriate behavior
d)
adhereto all of the above
7.
Multi-plate clutches are often used when there is not much space AND:
a)
a high torque has to be transmitted
b)
the rate of wear needs to be reduced
c)
the frictional force has to be increased
d)
the friction has to be decreased
8.
When carrying out a routine service you should report any defects to your supervisor so that:
a)
the customer can be contacted to get their authority
b)
you can't be blamed if the vehicle goes wrong
c)
you show to your supervisor that you are observant
d)
the additional parts required can be ordered
9.
The driver complains of difficulty engaging gears, especially. The most likely cause of thisis:
a)
clutch wear
b)
clutch slip
c)
clutchdrag
d)
clutch spring breakage
10.
Misaligned propeller shaft universal joints on a rear wheel drive car can cause:
a)
the transmission to vibrate
b)
the transmission to whine
c)
the clutch to judder
d)
the clutch to wear
11.
An automatic gearbox usually contains a:
a)
final drive differential
b)
sungear, planet gear and an annulus
c)
lay shaft and dog clutch
d)
limited slip differential
12.
The teeth on a RWD light vehicle final drive are;
a)
Hypoid
b)
Worm and wheel
c)
Helical
d)
Straight bevel
100 %
