WorksheetsLV08
Total questions: 12
Worksheet time: 4mins
Name
Class
Date
1.
What is the best way to test a hydraulic power steering system?
a)
Road Test
b)
Check for leaks
c)
Pressure test
d)
Listen for noise
2.
Which of the following is not a type of suspension system design
a)
Hydroelectric
b)
Active Dampening
c)
Cones
d)
Torsion Bar
3.
What does ABS stand for?
a)
Automatic Braking System
b)
Assisted Braking Software
c)
Applied Braking Support
d)
Assisted Braking System
4.
Which of these is not an ABS phase?
a)
Pressure Increase
b)
Pressure Hold
c)
Pressure Reduction
d)
Pressure Stabilisation
5.
Which of these is the correct method for jacking up a Landrover with Air Suspension?
a)
Open Passenger Door
b)
Set It On A Diagnostic Tool
c)
Open Tailgate
d)
Set Suspension To Lowest Setting
6.
What is the maximum slip angle tolerance?
a)
5-10%
b)
50-60%
c)
10-30%
d)
10-20%
7.
A steering angle sensor works out what?
a)
Steering wheel angle and its rotation speed
b)
Wheel speed and speed of steering wheel rotation
c)
Wheel direction and the rate of rotation
d)
The angle of the steering column in relation to the driver
8.
What is meant by vehicle rake?
a)
The toe in/out settings
b)
The ride height difference between front and rear
c)
Height of vehicle suspension
d)
Camber angle
9.
The power steering motor is usually...
a)
A 12V 3 phase DC motor
b)
A 12V 3 phase AC motor
c)
A 12V direct current motor
d)
A 415V direct current motor
10.
On hydraulic power steering, what is the most likely cause of heavy steering?
a)
Indicator bulb failure
b)
Faulty airbag squib
c)
Seized steering rack
d)
Auxiliary belt not fitted
11.
What waveform would an inductive type ABS sensor produce?
a)
Square wave
b)
Sine wave
c)
Saw tooth wave
d)
Calm wave
12.
What would most likely cause a vehicle to pull to the left and cause and ABS fault?
a)
Wheel alignment out of tolerance
b)
N/S/F tyre smaller size than O/S/F
c)
Faulty wheel speed sensor
d)
Both front tyre pressures low
100 %
