WorksheetsNet+ 3.2.6 Demo Questions
Total questions: 31
Worksheet time: 16mins
To answer these questions, you should watch the Demo video in Net+: 3.2.6; as you watch the video, you may need to pause to answer the questions. Do you understand?
I understand what to do
Wait...what? I need to ask for help
What is the terminal emulation program mentioned in the video?
PuTTY
TermEm
PoTTY
EmDoc
What port should you use to connect to a Cisco device?
Console port (RJ-45) for initial setup
What speed should PuTTY be set to?
Where does the image or IOS come from before it goes to RAM?
flash memory
regular memory
storage memory
memory
Does the demo follow the initial config dialogue?
Yes
No
Kinda
The first prompt you get is called?
user mode
exit mode
exec mode
priv mode
What did they type to bring up a dozen or so commands?
?
/
!
>
What 2 networking tools can you use in USER MODE?
How do you get to the next mode?
enable
disable
engulf
engle
Typing disable in CISCO IOS will
After typing enable, the prompt changes to a
>
<
#
%
Priv exec mode is like what account on a normal computer?
admin
user
temp
host
What is the running config?
current setup of the device
current RAM on the device
current rules of the device
current power of the device
After typing some of the command, what button on the keyboard will complete the command?
tab
shift
control
end
Clicking the ENTER key will
execute the command typed
cancel the command
produce an error
erase the config
Pressing the spacebar will allow us to go
one page at a time
one line at a time
one paragraph at a time
one character at a time
What should you type to enter into global config mode
conf t
configure now
configure glob
global int
Select the task you CAN'T do in global config mode.
change host name
change interface commands
setup routes
adjust power settings
When the prompt changes to config-if, it means
you are configuring an interface
you are configuring a setting
you are configuring the switch
you are not configuring anything
When configuring an interface, the settings you change
only affect that interface
affects all interfaces
does not affect any interface
changes the interface number
What happens when this is typed in global config mode on an interface?
ip address 10.0.0.2 255.255.255.0
an ip address is assigned to the interface
an ip address is assigned to the port
an ip address is assigned to the switch
an ip address is assigned to the network
Typing no shut does what?
turns the interface on
turns on the switch on
turns the router on
turns the settings on
Typing exit will
go back a level from where you were
exit the CLI
save and write to mem
go back two levels
Press this combinations to go all the way back.
Control+C
Control+B
Shift+C
Shift+B
Another command to take us all the way back is
exit
end
send
enter
T/F: there is on ONLY way to use commands on a network device.
true
false
While the device is on, the running config is stored where?
DRAM
SDD
HDD
ROM
If the devices powers off without saving, what will happen?
All changes revert
All changes stay
All changes come back eventually
All changes happen
Which command would copy the running config to the startup config?
copy run start
copy run run
copy start run
copy copy run
Pressing the UP arrow does what?
cycles through previous commands
turns the switch power up
goes through the running config
