WorksheetsLift Safety and Operation Quiz
Total questions: 15
Worksheet time: 8mins
What must be ensured before going under a vehicle on a lift?
The lift pads are clean
The lift is in the locked position
The vehicle is raised to maximum height
The vehicle is evenly loaded
What should be used to assist load changes while working on a lift?
Short jack stands
Tall jack stands
Hydraulic jacks
Wooden blocks
Who should not drive their own vehicle onto the lift?
Employees
Technicians
Supervisors
Customers
What should be done if tight bolts are encountered during vehicle repairs?
Use a manual wrench
Ignore them
Use an air impact wrench
Use a hammer
How should the brake fluid supply line be treated when removing the caliper?
Disconnect it
Let it hang freely
Suspend the caliper without pulling the supply line taut
Tie it tightly
What should you do if the runout measurement of the brake disc is unacceptable?
Replace the disc
Rotate the disc to a different position and repeat the measurement
Ignore it
Clean the disc again
What should be done to the brake pedal after fitting new brake pads?
Depress it once
Pump it a few times
Leave it alone
Adjust it manually
What is the purpose of bedding in new brakes?
To make the brake pedal feel spongy
To ensure the brakes operate correctly and last appropriately
To wear out the new pads quickly
To test the vehicle's speed
How often should brake pads be checked?
Every 10,000 miles
Every 20,000 miles
Every 30,000 miles
Every 40,000 miles
How often should brake pads be replaced?
Every 5,000 miles
Every 10,000 miles
Every 20,000 miles
Every 40,000 miles
What must be done before starting to replace brake pads?
Clean the vehicle
Remove the brake fluid reservoir cap
Remove all wheels
Disconnect the battery
How should the caliper be treated after removing it from the mount?
Hang it safely using ties or a bungee cable
Let it hang freely
Place it on the ground
Disconnect it completely
What should be checked with new brake pads before refitting the wheel?
The tyre pressure
The brake pedal travel
The brake light function
The vehicle's alignment
What should be used to ensure the wheel is tightened to the correct setting?
A wheel brace
A torque wrench
A ratchet
A hammer
What is the purpose of the spring compressor tool?
To remove the wheel
To remove the brake pads
To safely compress coil springs
To measure runout
