WorksheetsExterior Wall Framing
Total questions: 10
Worksheet time: 8mins
The section view of the house plans will specify the ________-to-finished-ceiling height.
finished-floor
unfinished-floor
subfloor
baseboard
What is the first step in determining stud length in platform construction according to Figure 37-1?
What is the component labeled at the top of the story pole in the diagram?
Sole Plate
Top Plates
Cripple Stud
Header
If the opening is made too large, what might not cover it?
something
everything
nothing
anything
Jambs may vary in ________.
size, shape, or material
color, texture, or design
weight, density, or volume
length, width, or height
The function of a Non-Load-Bearing Partition as shown in the diagram is:
To support structural loads
To divide spaces without supporting loads
To provide thermal insulation
To enhance the building's exterior appearance
Load-bearing partitions (LBPs) run perpendicular to the joists and support the ends of the joists above. True or False?
True
False
What is the purpose of the layout wall components as shown in the diagram?
To determine the height of the wall
To measure from the building line
To decide the color of the wall
To calculate the cost of materials
On architectural prints, interior partitions are usually dimensioned to their ________.
dimensions
edges
centers
corners
What is the first step in laying out a partition intersection according to the diagram?
A) Measure the full width of the partition stud
B) Lay out studs for partition intersection on both sides of center
C) Measure 1/2 width of the partition stud in both directions
D) Dimension to centerline of partition
