WorksheetsCARPENTRY LEVEL ONE MODULE 27103-13 EXAM
Total questions: 19
Worksheet time: 10mins
A leveling device that can be used for checking the level around obstructions is the ____.
water level
builder's level
laser level
line level
The most commonly used leveling instrument for building layout, construction, and surveying due to ease of use and rapid set-up time is the ____.
framing square
water level
builder's level
auto level
The tool shown is a ____.
try square
Speed SquareTM
adjustable T-square
sliding T-bevel
A handsaw that is used for rough cutting, such as cutting access holes for piping and electrical boxes, is commonly called a ____.
keyhole saw
dovetail saw
back saw
coping saw
The type of edge cut shown is known as a _____
dado cut
bevel cut
mortise cut
chamfer cut
Which of these statements about power tool safety is not true?
You should use only power tools that meet OSHA standards.
Do not operate a power tool if your hands or feet are wet.
Most power tools need to be plugged into a GFCI.
Always wear eye protection when using power tools.
Which type of blade is used with a demolition saw?
A chisel-tooth combination blade
An abrasive wheel
A carbide-tipped blade
A combination rip blade
A circular saw blade designed for cutting plywood should have _____
large, scissor-like teeth
large, widely spaced teeth
small, scissor-like teeth
small, widely spaced teeth
The type of saw that is ideal for cutting crown molding is the _____
portable table saw
circular saw
sliding compound miter saw
chop saw
The throat capacity of a drill press is ____.
the largest drill the chuck can hold
the distance from the table to the chuck
the distance the drill can be raised and lowered
the distance from its rear post to the center of the bit
Which type of router bit is preferred for use with most materials?
Carbide-tipped steel
High-speed steel
Carborundum
Fiberglass
The main function of a router is to ____.
drill holes in wood
cut metal
cut patterns in wood
plane lumber
A tool that can be used to make cuts in sheet metal, metal strips, special lightweight material, and steel studs is ____.
a. a circular saw
b. a router
c. a ripsaw
d. power metal shears
Which of the following operations would normally be done using a pneumatic stapler rather than a power nailer?
Installing finish work
Installing insulation
Constructing cabinets
Installing framing
What type of cut is also referred to as a plunge cut ?
pocket cut
What is the most common safety feature on a circular saw ?
lower Blade guard
What type of square is used to transfer and duplicate angles ?
Speed square
sliding T- bevel
Which hand plane is used to plane long boards ?
Which tool would you use when ripping boards less than 4" wide ?
Push-stick
