Font size
WorksheetsModule 00104 Exam: Introduction to Power Tools
Total questions: 18
Worksheet time: 9mins
Before connecting any power tool to a power source, it is critical to _____.
make sure the tool has been cleaned and oiled
ask your supervisor for permission
confirm the power switch is set to OFF
confirm the condition of all the tool's attachments
When using power tools, NEVER engage the _____.
locking spring
booster
bit shank
trigger lock
Before replacing parts such as bits, blades, or discs on any tool, it is important to _____.
disconnect the power source
recharge the tool's battery
polish it with fine steel wool
check the tool's oil level
The part of a drill that holds the drill bit in place is called the _____.
auger
ram
shank
chuck
When using an appropriate bit, variable speed drills can be used like a(n) _____.
hammer drill
impact driver
screwdriver
mag drill press
Before using a hammer drill or rotary hammer to drill into concrete, it is important to _____.
install a flying debris guard on the drill chuck
review silica exposure standards
confirm the location of coworkers
spray down the concrete surface with water
A pneumatic drill is commonly used _____.
when electricity is unavailable
to drill in tight, small areas
in areas where noise is a problem
to perform precision work
Never use a circular saw that does NOT have an upper blade guard because the _____.
trigger lock will not work properly
safety features will be disabled
exposed blade poses a danger
saw kerf will be too wide
The most important maintenance on a circular saw involves the _____.
upper blade guard
blade's sharpness
battery charge
lower blade guard
When using a circular saw, be sure to cut on the waste side of the cut mark to allow for the blade's _____.
uptake
stroke
angle
kerf
Saws with fine blades that are excellent for delicate and intricate cutting are called _____.
jigsaws
bandsaws
abrasive saws
worm-drive saws
The coarseness of a bandsaw's blade is rated in _____.
revolutions per minute
teeth per inch
length of the blade's teeth
hardness of the blade's teeth
A power miter saw combines a miter box with a _____.
bandsaw
jigsaw
reciprocating saw
circular saw
Crosscutting with a table saw involves cutting the wood _____.
to a specific width
with the grain
to a specific length
before it cures
Compared with powder-actuated nailers, electric and pneumatic nailers _____
are both stronger
require more training
do not require certification
are much slower
Before using a pneumatically powered nailer for the first time, it is important to _____
disassemble the nailer for inspection
load the nails into the nailer
ensure it is plugged into a GFCI receptacle
read the manufacturer's manual
Most craftworkers who use pneumatic nailers operate their compressors at _____
30 to 80 psi
60 to 110 psi
70 to 120 psi
90 to 140 psi
A Porta-Power® is an example of a(n) _____
electric tool
pneumatic tool
hydraulic tool
battery-powered tool
