wayground logo

Free Printable Worksheets

Font size

S
M
L
XL
Worksheets

Concrete Quiz Review

Total questions: 17

Worksheet time: 9mins

Name
Class
Date
1.

Which are the ingredients that are needed to create concrete?

a)

Portland cement

b)

Course Aggregate (Rock)

c)

Fine Aggregate (Sand)

d)

Rebar

e)

Water

2.

Which are the ingredients that are needed to create mortar?

a)

Portland cement

b)

Course Aggregate (Rock)

c)

Fine Aggregate (Sand)

d)

Rebar

e)

Water

3.

True or False: Mortar is also referred to as grout.

a)

True

b)

False

4.

What is the mixing ratio for footing? (Portland Cement, Sand, Gravel)

a)

1:2:4

b)

1:2:3

c)

1:3

5.

What is the mixing ratio for Slabs? (Portland Cement, Sand, Gravel)

a)

1:2:4

b)

1:2:3

c)

1:3

6.

What is the mixing ratio for Mortar? (Portland Cement, Sand, Gravel)

a)

1:2:4

b)

1:2:3

c)

1:3

7.

During the excavation process, if the basement is dug too deep what material should the basement be backfilled with?

a)

Dirt

b)

More Concrete

8.

In Wisconsin at what depth is the frost line located?

a)

2'-0"

b)

3'-0"

c)

4'-0"

d)

8'-0"

9.

Common footing designed only to carry light loads

a)

Plain Footing

b)

Stepped Footing

c)

Reinforced Footing

10.

footing that changes grade levels at intervals to accommodate a sloping lot

a)

Plain Footing

b)

Stepped Footing

c)

Reinforced Footing

11.

footing with embedded steel or rebar to increase strength.

a)

Plain Footing

b)

Stepped Footing

c)

Reinforced Footing

12.

What is the minimal slab thickness for a basement/concrete slab?

a)

3"

b)

4"

c)

6"

d)

8"

13.

Leveling the surface is called?

a)

Screeding

b)

Edging

c)

Jointing

d)

Floating

e)

Troweling

14.

Rounding an edge to prevent chipping is called?

a)

Screeding

b)

Edging

c)

Jointing

d)

Floating

e)

Troweling

15.

Cut control or contraction joints is called?

a)

Screeding

b)

Edging

c)

Jointing

d)

Floating

e)

Troweling

16.

Brings up mortar to desired finish is called?

a)

Screeding

b)

Edging

c)

Jointing

d)

Floating

e)

Troweling

17.

This process leaves a smooth finish called?

a)

Screeding

b)

Edging

c)

Jointing

d)

Floating

e)

Troweling