Very often, repairs to a control surface require static rebalancing of the control surface. Generally, flight control balance condition may be determined by.

Near-vertical wingtip extensions used to reduce aerodynamic drag are called:

The universal propeller protractor can be used to measure a. aspect ratio of a wing. b. degrees of flap travel. c. propeller track.

Large aircraft flight control systems include:

When conducting a magnetic particle inspection, what must be done to a part before it can be tested?

Why are aircraft not operated in cruise conditions near Mach 1?

What is the most widely used technique used when conducting an electromagnetic analysis?

Large airplanes and turbine-powered multiengine airplanes operated under Federal Aviation Regulation Part 91, General Operating and Flight Rules, must be inspected:

The SRM contains information and instructions for repairing primary and secondary _________________.

Which primary flight control surface provides lateral control of an aircraft?

Which type of aircraft operate in an environment that dramatically accelerates corrosion?

What FAR can one use to determine if a repair is a major or a minor repair?

Which aircraft flight axis extends from wing tip to wing tip?

An aircraft that is due an annual inspection may be flown:

What type of inspection is for hard landings at or below the maximum design landing limits?

Trim tabs move in the same direction of the flight control surface and are not adjusted by the pilot.

What contains step-by-step instructions covering work performed on a unit that has been removed from the aircraft?

Compliance with an Airworthiness Directive (AD) is:

Which aircraft inspection program must be completed once a year?

Who issues Service Bulletins?

The Federal Aviation Administration regulations that govern USA civilian aircraft are found in which Title of the Code of Federal Regulation?

The Representative of the Administration is regulated under which FAR?

A checklist for a 100-hour/annual inspection may be of your own design.

Visual inspections are not considered a method of nondestructive inspection.

Ailerons are controlled by which movement of the control yoke?

What type of flap system increases the wing area and also changes the wing camber?

The chord of an airfoil is an imaginary straight line that passes through the airfoil from the:

Which statement about Airworthiness Directives (ADs) is true?

What are slats?

Repair stations are governed under which FAR?

Newton’s third law is the law of:

The correct dihedral angle can be determined by

The angle of incidence of an airplane at rest

When doing an inspection, which of the following is required by the FAA?

Is AD compliance mandatory?

Where would you find the recommended statement for recording the approval or disapproval for return to service of an aircraft after a 100-hour or annual inspection?

The NOTAR antitorque system has no visible rotor mounted on the:

Which of the following is considered subsonic speed?

Which of the following are the three primary flight controls on a airplane?

What is the record where all data concerning the aircraft?

The dihedral angle of a wing may be measured by placing a straightedge and level protractor on the a. wing chord b. wing root c. front spar.

When an inspection or maintenance action is completed, what action is required before an aircraft may be returned to service?

When alterations to an aircraft are made that are not specified or authorized in the TCDS, what must be issued to the aircraft owner, by the FAA, for the aircraft to remain legal to fly?

The chord of a wing is measured from a. wingtip to wingtip. b. wing root to the wingtip. c. leading edge to trailing edge.

Aircraft wings may extend perpendicular to the horizontal plane of the fuselage or can angle up or down slightly. This angle is known as:

When a fiber or nylon insert-type, self-locking nut can be threaded on a bolt or stud through the insert with only the fingers, it should be