With a pull-type clutch adjustment, the need for linkage adjustment is normally caused by wear in the _______ system

A large amount of heat can cause the metal on the flywheel, pressure plate, and the intermediate plate to get so hot that it begins to smear across the surface:

A smooth flywheel will cause chatter:

Can burnt smell be a indication of clutch wear:

What are the adjustments(aspects) for the proper clutch pedal: ____ ____ & _____ (more than one answer)

Heavier clutches can weigh up to ___ lb and may require the use of a clutch jack.

The cross shaft should protrude through the shift fork in the bell housing:

When bleeding a hydraulic-clutch system, what are we trying to remove from the system:

Self adjusting clutches are packaged with _____ when shipped and need to be removed before the cover is tightened to the flywheel

What part of the flywheel do you put the dial indicator to check warping:

What should be used to move the solo wear tab to "new" position on a self adjusting clutch:

When removing the transmission, use extreme caution not to allow it to hang from the:

The Eaton Solo, SACH"s twin XTend, and Meritor Autojust self-adjusting clutches have replaced the large internal adjusting ring with a set of movable ___ rings

The inspection and repair of clutch components: from the clutch brake, measure the distance between the forward end of the input shaft splines to the friction surface of the input bearing cover, the distance should not exceed:

another term for "throwout bearing":

Which style of clutch linkage was on the MACK that was used for clutch adjustment demonstration this semester in the shop:

With the MACK that we used for demo, would we adjust the forks or the linkage for the proper gaping between release bearing and forks:

Components used for angle-spring clutch adjustment: (multiple choice)

Which of these are not a form of bleeding a hydraulic system: