WorksheetsAir/Brad Nailer Safety Quiz
Total questions: 10
Worksheet time: 5mins
Before using an air/brad nailer, what is the first thing you should do?
Plug it into the power source
Check that it is clean and free of obstructions
Load the nails
Test it on a piece of wood
What safety gear should you wear when using an air/brad nailer?
Sunglasses
Safety goggles
A hard hat and knee pads
Earplugs and flip-flops
Which of the following is important when loading nails into an air/brad nailer?
Only load nails that are the right size for the tool
Overload the magazine to save time
Use nails from any brand, regardless of size
Tap the nails in with a hammer
What should you do if a jam occurs in the nailer?
Turn the tool upside down and shake it
Use your hands to force the jam out
Disconnect the air supply, then clear the jam carefully
Keep using the tool to try to clear the jam
How should you position your hand when holding the air/brad nailer?
Keep your hand away from the nozzle and trigger
Place your hand over the nozzle to control the airflow
Hold the tool with both hands, one near the trigger
Always place your hand directly under the tool
When is it safe to remove your finger from the trigger of the air/brad nailer?
Only when the tool is not loaded with nails
After firing a nail
When you are setting up to use the tool
Never remove your finger from the trigger
How should you store the air/brad nailer when not in use?
Leave it on the floor or table
Place it with the trigger facing up on a flat surface
Hang it up with the air hose attached
Store it in a safe, dry place away from children
What is the correct way to fire the air/brad nailer?
Press the nose into the surface you are nailing, then pull the trigger
Hold the tool against your body, then pull the trigger
Aim the tool at the ground and fire
Fire the tool from a distance
What should you do if you need to make adjustments to the air/brad nailer?
Adjust the settings while the tool is still plugged in and pressurized
Always make adjustments when the tool is off and air supply is disconnected
Adjust the tool while it's firing to see results
Hand the tool to an adult for adjustments
What is the proper way to dispose of used nails or other debris from the tool?
Leave the debris in the tool for future use
Sweep up the debris and discard it in the trash
Throw the debris in the air to clean the area
Keep the debris in the tool until it's full
