For any network connection, the speed is only as high as the __________ device connected.

A layer 3 switch has both switching and __________ capabilities.

Backplane speed is the total __________ a switch is capable of at any given time.

In Hyper-V, virtual switches can have external, internal, and __________ connections.

In dynamic routing, routing __________ are formed and updated as routers enter and exit a network infrastructure.

RIP uses __________ to determine the best route for data packets.

The IPv4 address for a default route is __________.

Routing tables use __________ within a router for storage.

What is the maximum distance most twisted-pair cables can carry signals?

A switch port shows a yellow LED light when a cable is connected to it. What does this most likely indicate?

What is the difference between a managed switch and an unmanaged switch?

You have a single switch but need for the switch to host two networks. What can you create on the switch?

What does a hub not store that a switch stores?

TRUE or FALSE. A broadcast storm is a type of loop in which broadcasts flood through a switch, eventually overloading it.

At what speed will data transfer out of Fast Ethernet ports on a wireless router?

A route with one hop is called a:

What is a default route in a routing table?

How many physical networks should an administrator create for a university campus with several buildings including a registrar’s office, health center, library, auditorium, and student hall?

What resumes once convergence has been completed?

Which fiber optic cable mode carries one ray of light over long distances?

What color is the wire connected to Pin 1 in the 568b standard?

What is the color of the wire connected to Pin 5 in the 568b standard?

Which pin is connected to a blue wire in both 568a and 568b standards?

Which pin is connected to a brown wire in both 568a and 568b standards?

A signal on one pair of wires in a twisted-pair cable is interfering with another wire in the same cable. What is taking place?

In which network topology is data transmission token-based?

Which of these IP addresses are public?

Which IP address can an administrator ping to test a network card on a device?

Which IP address is an example of APIPA?

To what are wireless LANs more susceptible than wired LANs?

Which best describes the type of connection generated from a leased line?

Which is the top advertised speed for a dial-up connection?

How many 64 Kbps channels are used for a basic ISDN?

On what circuit does a PRI run?

Which form of wireless encryption is considered weak, as it has been cracked?

How many connections are in a full mesh network with four devices?

The topology in which a switch usually serves as a central point:

The topology in which network connections provide redundancy

The topology in which only one device can transmit at a time

The topology that must have terminators on both ends

A __________ topology describes how data flows through a network, while a __________ topology is the actual appearance and setup of a network.

A network is set up with a central device but only one token transmits at a time. The network is a _________ star and a ___________ ring.

Which IPsec protocol involves generating authentication and encryption keys.

Which IPsec protocol provides authentication and integrity of data?

Which IPsec protocol provides authentication, integrity, and encryption of data?

Which form of DSL has a much higher download speed than upload speed?

Which is true about an Internet service using DSL and a cable modem?

What is the biggest issue with satellite internet?

Which form of wireless encryption is considered weak, as it has been cracked?