WorksheetsSmall Gas Engine: Disassembly Procedures
Total questions: 15
Worksheet time: 8mins
Which of the following engines is featured in the disassembly procedures presentation?
Kohler® Command Pro CH 270
Kohler® Command Pro CH 260
Kohler® Command Pro CH 395
Kohler® Command Pro CH 440
In the presentation, what is used to keep the assembly sequence of the levers and linkage together?
A piece of tape
A plastic bag
A nylon or wire tie
A rubber band
How many valves are in the engine featured in this presentation?
One
Six
Four
Two
Before disassembly, the fuel lever needs to be moved in what direction?
All the way to the left
All the way to the right
To the neutral position
To the stop position
Which of the following steps needs to occur before the carburetor is removed from the engine?
The fuel tank should be removed
Fuel should be drained from the carburetor
Electrical systems need to be disconnected
The engine oil needs to be drained
Which of the following should be used to remove the breather hose from the valve cover?
Pliers
Wrench
Fingers
Screwdriver
Which of the following steps should be used to remove the valves from the cylinder head?
A. Push down on the keeper
B. Pull up on the keeper
C. Use a valve puller
D. Tap out with a hammer
How many push rods are in the engine featured in this presentation?
Six
Four
Two
Eight
In the presentation, Scott Mack labels one of the tappets with the letter “I.” What does this stand for?
Ignition
Intake
Inverted
Internal
In order to properly remove the flywheel from the crankshaft, what tool should be used?
Pry bar
Pliers
Flywheel Puller
Hammer
Which of the following is used to catch oil as it drains from the crankcase?
Funnel
Catch tank
Crankcase pan
Suitable catch pan
According to the presentation, what should be done with the parts that will be reused?
They should not be reused
They should be clearly marked upon removal
They should be retrofitted
They should be resized
In the presentation, Scott Mack labels one of the tappets with the letter “E.” What does this stand for?
External
Extension
Exhaust
Electrical
Which of the following should be removed prior to removing the cylinder head from the engine?
Cylinder head screws
Rocker arms
Valve keepers
Valve springs
In the presentation, Scott Mack recommends marking the position of the governor spring where it attaches to the governor lever and throttle lever. Which of the following is another option?
Draw a diagram
Color coordinate parts
Bag all parts together
Take a digital picture
