Worksheetsbatteries
Total questions: 26
Worksheet time: 9mins
Which circuit is a complete circuit? A or B
Is the switch on the Positive or Negative side of this circuit?
Positive
Negative
What should the volt meter read? (switch is open)
12V
9V
6V
0V
What should the volt meter read? (switch is open)
12V
9V
6V
0V
Where should the voltmeter be placed to test the switching function of the Transmission Control Module? (TCM)
Location A
Location B
Location C
This is an example of a digital signal
True
False
An automotive rotational speed sensor will produce an:
Analog voltage signal
Digital voltage signal
Either depending on the type of sensor
The electrical symbol shown in the figure represents the :
Lamp
Switch
Resistance
Battery
The type of headlight bulb shown in the figure is called a/an :
Xenon bulb
Quartz-halogen Bulb
Light emitting diode bulb ( LED )
Ordinary bulb
True or False: All the electrons in the battery are balanced, which causes the movement of electrons.
True
False
Alternators are more efficient when charging at higher speeds.
True
False
Old batteries with high resistance require the alternator to work _____ to charge them.
more efficently
less
harder
less efficiently
A battery high rate discharge (load capacity) test is being performed on a 12-volt battery. Technician A says that a good battery should have a voltage reading higher than 9.6 volts while under load at the end of the 15-second test. Technician B says that a battery should be discharged (loaded to two times its CCA rating). which technician is correct
Tech A
Tech B
Both techs are correct
Neither tech is correct
When Jump Starting a vehicle, _____________.
The last connection should be the positive post of the dead battery
The last connection should be the engine block of the dead battery
The last connection should be the negative post of the dead battery
The last connection should be the engine block of the good battery
t
When measuring battery voltage, set the meterto read...
AC Volts
DC Volts
Hertz (Hz)
Amperes (A)
Which battery rating is used mostly when testing a battery to see if it is performing normally? (be careful!)
Cranking Amps(CA)
Cold Cranking Amps(CCA)
Ampere-Hour Rating(Ah)
Reserve Capacity(RC)
What is the mnemonic (memory device) that is used to remember the 4 cycles (strokes) of the internal combustion engine?
ICPE
ICCE
IPPE
IICE
