One cubic metre of mild steel weight about

Which structural design method primarily considers only the material factor of safety when determining permissible stress levels?

The maximum permissible stress in axial tension

Permissible stress in maximum shear stress should not be greater than:

Structural steel of grade Fe410 A has ultimate tensile strength of

An example, for the designation of a steel I-section, is

ISMB 200 is a hot rolled Standard Indian Steel Section in which 200 indicate

which of the following sections are mostly used as columns

Which among the flowing is also known as rolled steel joist ?

Designation of a rolled steel plates, is

The steel flats are designated by ______. 

ISSQ stands for

Partial safety factor of a material governed by yielding

-- is used where projection of the rivet head is to be avoided

What is the maximum permissible longitudinal pitch in staggered rivetted compression joints

For reversal of stress the most suitable bolt is

If the same number of rivets has been used in the joints then which of the following pattern will yield highest efficiency

The minimum spacing for M20 bolts, of grade 4.6. According to IS 800 is

The diameter of bolt hole for a bolt of nominal size 12mm is

Failure by block shear at an end connection of a plate involves

The shear capacity of bolts is reduced

1. 1. When total thickness of connected plates exceeds 5 times the nominal diameter of bolts.

2. 2. When packing plates are more than 6mm thick

Ribbed bolts are also known as ____.

Least value of design strength of bolt in bearing, design strength of bolt in shear is known as