WorksheetsNetwork+ Assessment Quiz Edu
Total questions: 70
Worksheet time: 1hrs 10mins
Sibongile is an employee of XYZ Co. Which of the following policies would Sibongile have to agree to when she brings in her personal computer to connect to the company’s guest wireless Internet?
NDA
IRP
BYOD
SLA
Adriaan is a network engineer designing a new IDF in an old building. He determines the equipment will fit in a two-post rack, and there is power available for this equipment. Which one of the following would be the first issue to remediate?
Air flow and cooling
UPS capability
Circuit labelling
Power redundancy
A cyber attacker executes a man-in-the-middle attack on a company network. Layer 2 traffic destined for the gateway is redirected to the attacker’s computer. This type of attack is an example of:
ARP cache poisoning
IP spoofing
amplified DNS attack
evil twin
Sifiso is troubleshooting an end-user connectivity problem. He goes to the appropriate IDF but is unable to identify the appropriate cable due to poor labelling. Which of the following should the Sifiso use to help identify the appropriate cable?
Tone generator
Multimeter
OTDR
Loopback adapter
Karabo is a network engineer for NetworkIT Co. She notices the site-to-site VPN and Internet connection have not come back up at a NetworkIT Co. branch office after a recent power outage. Which of the following is an out-of-band method Karabo would most likely make use of to check the branch office’s router status?
Hire a contractor to go on-site
Walk a user through troubleshooting the connection
Travel to the branch office
Use a modem to console into the router
Marlize is a graduate network technician for Cable Solutions Co. She recently installed a fiber switch in a datacentre. To run the fibre cabling, Marlize plans the cable route over the top of the rack using the cable trays, down to the switch, coiling up any excess cable. During the time Marlize configures the switch, she notices several messages in the logging buffer stating the receive signal of the SFP is too weak. Which of the following is most likely the cause of the errors in the logging buffer?
Fiber cable mismatch
Bend radius exceeded
Fiber type mismatch
Bad fibre switch
Mxolisi, a network engineer, configures a firewall’s ACL to allow outgoing traffic for several popular services such as email and web browsing. However, after the firewall’s deployment, users are still unable to retrieve their emails. Which one of the following would best resolve this issue?
Allow the firewall to accept inbound traffic to ports 25, 67, 179, and 3389.
Allow the firewall to accept inbound traffic to ports 80, 110, 143, and 443.
Set the firewall to operate in transparent mode.
Allow the firewall to accept inbound traffic to ports 21, 53, 69, and 123.
When enabling jumbo frames on a network device, which of the following parameters is being adjusted?
Speed
Duplex
MTU
TTL
Palesa is a network engineer for a local company. During a certain day, she logs onto a system using Telnet because SSH is unavailable. SSH is enabled on the target device, and access is allowed from all subnets. Palesa discovers a critical step was missed. Which one of the following would allow SSH to function properly?
Perform file hashing.
Generate new keys.
Update firmware.
Change default credentials.
You have been hired as a network administrator for Network Solutions Co. Which of the following devices should you configure on the outermost part of the network?
Media converter
Switch
Modem
Firewall
Riaan, a network engineer, receives a call from a user who is experiencing network connectivity issues. Riaan questions the user and learns the user brought in a personal wired router to use multiple computers and connect to the network. Which one of the following has the user most likely introduced to the network?
Rogue DHCP server
Evil twin
VLAN mismatch
Honeypot
Which of the following is a system of notation that uses base 16 rather than base 10?
Binary
Octal
Hex
CIDR
Livhuwani, a network engineer, is reviewing the implementation requirements for an upcoming project. The basic requirements identified by the customer include the following: WLAN architecture supporting speeds in excess of 150 Mbps, Clientless remote network access, Port-based network access control. Which one of the following solutions sets properly addresses all of the identified requirements?
802.11a, IPSec VPN, 802.1x
802.11ac, MPLS, 802.3
802.11b, PPTP, 802.1x
802.11g, MS-CHAP, 802.16
802.11n, SSL-VPN, 802.1x
Which one of the following is used to classify network data for the purpose of providing QoS?
STP
VLANs
SIP
DSCP
Which one of the following is the number of broadcast domain that are created when using an unmanaged 12-port switch?
0
1
2
6
12
James, a senior network technician has noticed the corporate wireless signal is available in the parking lot. James’s company management requests that the wireless network be changed so it is no longer accessible in public areas, without affecting the availability inside the building. Which one of the following should be changed on the network?
Power levels
Overcapacity
Distance limitations
Channel overlap
Zolelwa, a network technician, wants to ensure sensitive data is not exfiltrated from the system electronically. Which one of the following should be implemented?
DLP
AUP
NDA
SLA
Siyagijima is a local company. Their office network consists of one two-port router connected to a 12-port switch. A four-port hub is also connected to the switch. Which one of the following is the number of collision domains that exist on the Siyagijima network?
3
12
13
14
15
Andries is a network technician working for Global Consulting Solutions. On a certain day, Andries was diagnosing a time-out issue generated from an end user’s web browser. The web browser issues standard HTTP get and post commands to interact with the website. Given this data, Andries would like to analyse the entire TCP handshake of the HTTP requests offline. Which one of the following tools would allow Andries to view the handshake?
Packet analyzer
Port analyzer
SNMP traps
Spectrum analyzer
Which one of the following must be implemented to share metrics between routing protocols within the same router?
Routing loop
Routing table
Route redistribution
Dynamic routes
A node refers only to a workstation or servers.
True
False
A subnetwork or subnet refers to a physical grouping of hosts within a single network.
True
False
TCP/IP is an open standard protocol.
True
False
A company network exists linking Johannesburg, Pretoria and Durban. This can be referred to as a?
LAN
MAN
WAN
CAN
What is the Administrative distance of EIGRP?
90
110
54
7
The IEEE 802.3z standard specifies 'Gigabit Ethernet' running at 1000 mbps.
True
False
On a single channel 802.11n devices can transfer data at a rate of up to 54Mbps.
True
False
The IEEE 802.3u standard specifies:
Gigabit Ethernet running at 1000 Mbps
Fast Ethernet running at 100 Mbps
'10G' running at 10Gbps running over fiber.
Ethernet running at 10Mbps
In the Ethernet specification what is the minimum cable length still considered to be viable?
100 m
10 m
0,5 m
5 m
Which one of the following is not an element in the construction of a single optical fibre?
Core
Pulse light
Cladding
Buffer
You are the network administrator. You have been asked to set up a separate network in the building which will service the most confidential and valuable data in the company. Security is of the highest importance and cost is only of secondary importance. Which of the following cable type will you use?
UTP
STP
Fibre Optic
Coaxial Cable
The Attenuation is measured in mW (milliwatts)
True
False
In the Public Switched Telephone Network which of the following is referred to as a Class 5 office or Central Office?
Local loop
Local exchange
Trunk offices
POTS
The BRI class of ISDN provides:
Two 64 Kbps D channels for data and one 16 Kbps B channel for control.
Two 16 Kbps D channels for data and one 64 Kbps B channel for control.
Two 64 Kbps B channels for data and one 16 Kbps D channel for control.
Two 16 Kbps B channels for data and one 64 Kbps D channel for control.
A network adapter’s address is also known as a MAC address. What does MAC stand for?
A network adapter’s address is also known as a MAC address. What does MAC stand for?
Modular Access Control
Modular Address Control
Media Address Control
Media Access Control
DHCP stands for?
Defined Host Configuration Protocol
Dynamic Host Configuring Protocol
Dynamic Host Configuration Protocol
Delimited Host Configuring Protocol
Which of the following is the default subnet masks for Class A.?
11111111.11111111.00000000.00000000
11111111.11111111.11110000.00000000
11111111.11111111.11111110.00000000
11111111.00000000.00000000.00000000
What is the port number for Simple Network Management Protocol?
110
161
119
139
You wish to use a routing algorithm that is manually defined and needs to be edited if you wish to change any information. Which category of algorithm best describes what you need?
Static
Hierarchical
Link-State
Distance Vector
The Domain Name System is operated by?
IANA
OSPF
ARIN
ICANN
What cabling faults would a wire map tester detect
Opens
Shorts
Transpositions (reversed and crossed pairs)
A backbone refers to a fast link between 2 other segments on a network.
True
False
The first layer of the OSI model is the application layer.
True
False
RFC stands for Request for Commitments.
True
False
Which of the following can be referred to as a client machine?
A computer that provides print services
A computer that enables file sharing services with other PC’s
A machine that uses the network to access applications
A machine that resolves network addresses and names
Which of the following is not a layer 2 device?
Bridge
NIC
Router
Wireless access point
The 802.11a standard transmits at a frequency of 2.4GHz.
True
False
A MAC address consists of 32 binary digits.
True
False
The entire bandwidth of your transmission media is dedicated to a single transmission path. This is best referred to as:
Broadband transmission
Baseband transmission
Analogue transmission
Singleband transmission
The longer a signal travels over a cable the more progressively it loses signal strength. This is best described as:
Noise
Cross talk
Attenuation
Nulling
Twisted Pair Cabling uses which type of connector?
RJ-11
RJ-45
BNC
ST
Which one of the following best describes Coaxial cable?
A type of copper cable using 2 or 4 pairs of twisted cable.
A type of cable made of two conductors that share the same axis.
An optic cable which uses pulses of infrared light for signalling.
Cable consisting of 4 or 6 wires, 4 for data and 2 for powering devices.
Impedence is measured in:
Amps
Volts
Watts
Ohms
MTRJ connectors are used on multimode networks.
True
False
It is possible to send multiple signals over a single fibre using Wavelength Division Multiplexing.
True
False
Wave Division Multiplexing is a means of making more use of the bandwidth available in a _____________ network.
Coaxial
Fibre Optic
Ethernet
Wireless
ATM uses cell switching technology. A cell is a fixed length packet that contains ____________ of data and _____________ of header information.
32 bytes; 5 bytes
48 bytes; 1 byte
48 bytes; 5 bytes
32 bytes; 1 byte
PSTN stands for?
Public Switched Transmission Network
Public Switched Telephone Network
Public Service Telephone Network
Private Switched Transmission Network
Network access points are administered by?
Internet Service Administrators (ISA)
Network Access Administrators (NAA)
Network Service Providers (NSP)
Internet Service Providers (ISP)
ISDN is a dial-up technology.
True
False
Frame relay cannot provide QoS (quality of service).
True
False
You enter the IP address manually into your IP settings. This is called a / an _____________ configuration.
Static
Dynamic
Automatic
Addresses
The subnet mask is 255.255.248.0. This can be represented in binary as?
11111111.11111111.11111100.00000000
11111111.11111111.11111111.00000000
11111111.11111111.11110000.00000000
11111111.11111111.11111000.00000000
Which of the following protocols is used for secure remote access to a network?
FTP
SSH
Telnet
HTTP
What is the primary purpose of a VLAN in a network?
To segment network traffic
To increase bandwidth
To enhance security
To provide redundancy
Which of the following is a common method for network address translation?
Static NAT
VLSM
Subnetting
Dynamic Routing
Which of the following protocols is used to securely access a remote device over an unsecured network?
FTP
HTTP
Telnet
SSH
What is the primary function of a router in a network?
To amplify network signals
To forward data packets between different networks
To provide a wireless connection
To connect multiple devices within the same network
Which layer of the OSI model is responsible for end-to-end communication and error recovery?
Transport Layer
Network Layer
Data Link Layer
Application Layer
