WorksheetsLSB Standard 02, Rev 03 Quiz
Total questions: 20
Worksheet time: 29mins
What is the primary purpose of the LSB Standard 02 regarding fire protection and life-safety equipment?
To provide guidelines for the installation of new fire protection systems
To ensure the inspection, maintenance, and testing of fire protection systems
To override specific requirements of manufacturers
To establish new fire safety equipment
What is the purpose of a "quick check" in the inspection of fire protection or life-safety systems?
To ensure the system is installed in the correct location
To provide a thorough examination of the system
To give reasonable assurance that the system will operate properly
To replace any damaged parts of the system
Who is responsible for conducting servicing, testing, and maintenance of fire protection and life-safety equipment?
Any employee of the company
Qualified personnel approved by the Fire Marshal
The building owner
The local fire department
What must be attached to a service tag after any service is completed?
A detailed report of the service
A copy of the owner's manual
A list of all employees involved
A photograph of the equipment
What color tag is used if a system is found to be unsafe or inoperable?
Blue
Green
Red
White
How many business days in advance must the Fire Marshal’s Office be notified for lengthy repairs?
3 business days
5 business days
7 business days
10 business days
Which of the following is NOT mentioned as part of the fire alarm system testing?
Smoke detectors
Manual pull devices
Fire extinguishers
Control units
What is the minimum duration for the load test of lead-acid battery systems?
30 minutes
60 minutes
90 minutes
120 minutes
What is required for the manual operation of a transfer switch?
Automatic equipment
Properly instructed personnel
Remote control
No specific requirements
What is the frequency for performing a full 'Trip Test' on all dry-pipe valves?
Annually
Every 2 years
Every 3 years
Every 5 years
According to the document, how often should a flow test be conducted on wet standpipe systems?
Annually
Every 2 years
Every 3 years
Every 5 years
What is the minimum pressure required for testing a dry standpipe system?
100 psig
150 psig
200 psig
250 psig
How often should hose connections and hose rack assembly pressure valves with pressure reducing devices (PRD) be inspected?
Every 2 years
Every 3 years
Annually
Every 10 years
How often should Fire Department Connections (FDC) be inspected according to the standard?
Annually
Quarterly
Every five years
Monthly
What is the minimum pressure required for hydrostatic testing of private fire main piping systems?
100 psi
150 psi
200 psi
250 psi
How often should the operating test of diesel engine driven fire pumps be conducted?
Daily
Weekly
Monthly
Annually
How often should electrically driven fire pumps be tested?
Daily
Weekly
Monthly
Annually
What is the required frequency for inspecting commercial kitchen hood systems?
Every month
Every 3 months
Every 6 months
Annually
What is the frequency of elevator inspections as mentioned in the document?
Monthly
Annually
Biannually
Weekly
Per City of Houston, the 5 year FDC hydrostatic test shall be tested up to which device
Backflow Preventer
FDC Check Valve
Sprinkler Riser Control Valve
None Of The Above
