WorksheetsScroll Saw Operation and Safety
Total questions: 15
Worksheet time: 8mins
Where is the on/off switch for the scroll saw typically located?
On the side of the machine
Underneath the table
On top of the machine
At the back of the machine
What is the recommended distance for the safety guard above the material being cut?
1/4 inch
1/2 inch
1/8 inch
As close as possible without touching
On which side of the scroll saw is the adjusting knob for the safety guard located?
Right-hand side
Front
Back
Left-hand side
To tighten the safety guard after adjustment, which direction should the adjusting knob be turned?
To the left
To the right
Clockwise
Counter-clockwise
What percentage is the recommended speed setting for the scroll saw?
50%
75%
100%
25%
Where is the speed dial located on the scroll saw?
Below the on/off switch
On the side of the machine
Above the on/off switch
On the front panel
If the speed dial goes up to 8, what value approximately corresponds to 75% speed?
4.5
6.5
7.0
8.0
What is the primary use of a scroll saw?
Cutting straight lines
Cutting curves
Sanding wood
Drilling holes
What is the minimum safe distance your fingers should be from the scroll saw blade?
1 inch
2 inches
3 inches
As close as needed
What tool should be used if your fingers need to be closer than 2 inches to the blade?
A clamp
A push stick
Gloves
Pliers
What is the immediate first step if the scroll saw blade breaks during operation?
Unplug the machine
Turn off the machine
Tell the teacher
Try to replace the blade
After turning off the machine, what is the next step if the scroll saw blade breaks?
Tell the teacher
Unplug the machine
Clear the work area
Inspect the blade
When is it safe to remove scrap pieces of wood from the scroll saw table?
While the machine is running slowly
Only after the machine is turned off
Anytime, as long as you are careful
When the blade is at its lowest point
What should be used to remove scrap pieces of wood from the scroll saw table instead of your fingers?
A metal ruler
A brush
Another scrap piece of wood or a push stick
Compressed air
What is the purpose of making relief cuts when cutting sharp curves or angles?
To make the cut smoother
To allow the wood to break off and prevent blade breakage
To create decorative edges
To speed up the cutting process
