Fill in the blank: ______ arm saws are fixed and designed to begin the cut at the back of the material.

Fill in the blank: Never let go of the material between the blade and the ______ when using a table saw.

You should maintain firm ______ when feeding materials into the table saw.

Fill in the blank: When using features such as ______ miters, always be aware of the path of the blade.

Usually ______ of an inch of the material is removed per pass.

A tool under ______ could indicate improper use or a dull blade or bit.

When Cutting with a Miter saw, hold the material tightly to both the ______ and the fence.

The band saw has a ______ blade which passes around two drive wheels and travels in a downward direction.

Which of the following should you use when necessary for smaller pieces on a band saw?

Scroll saws have a single blade which ______ up and down at various speeds.

Impact drivers and pneumatic _______ are often used in different shop settings. (Fill in the blank)

Fill in the blank: Band and ______ saws are often used in shops for cutting smaller pieces of material and cutting curves.

Not feeding the material into the cutting edge may cause the material to be pulled from your hand or the tool to ______.

Never operate a ______ with the guard removed. Unless the work being done prevents such use, but extra care should be taken and approval from your instructor. Fill in the blank.

Fill in the blank: Use a push ______ as necessary for small materials when using a table saw.

Fill in the blank: ______ saws are invaluable to carpenters building cabinets or installing trim materials.

Fill in the blank: Always start a ______ compound miter saw cut at the foremost point traveling backward through the cut toward the fence.

True or False: Always allow hands to travel directly in the path of the blade.

When examining drill presses or work areas, ensure there is ample ability to ______the material

Blades or router bits should be sharp and set to the appropriate ______.

Planners also have feed ______ which move the materials through the equipment.

Know what is being ________ and what is beyond the material.

Only use sockets or _______ rated for the tools being used.

Which saw has been the cause of many career ending injuries for many workers?

Keep fingers at least ______ inch away from the blade when using a scroll saw.

When using a jointer, use a ______ anytime your hand may possibly enter below the fence.

Routers and shapers are designed to use smaller ______, usually with one to three cutting edges.

What does PPE stand for in health and safety?

Which of the following is NOT an example of a mechanical hazard?

Table Saw (Part 2): Make sure the area is clear of debris, people and no one is in the ______ zone. Fill in the blank.

Fill in the blank: Band saws may cut wider ______ as well as milling materials in a similar manner to a sawmill.

Drills utilize ______ which can cause accidents if the material is not properly secured.

___________chucks should only be tightened by hand and you should never operate the drill to tighten the chuck