Which of the following is a major structural component in the REV Build System?

Channel in the REV Build System features a pattern for mounting actuators, brackets, and other elements at set intervals

Extrusion is heavier than Channel

Which of the following is Extrusion not recommended for?

REV C Channel has a higher torsional strength than Extrusion

REV Plates and Beams are not well suited for which of the following:

There are 3 major types of REV Brackets

Which of the following is not a type of REV Bracket?

REV Brackets come in metal and plastic

Motion Brackets contain a motion interface pattern

Structural Brackets can only connect to motors and servos

Actuator Brackets primarily come in metal with no plastic alternative

Which of the following is not a tool provided in the REV Build System?

When tightening a screw into extrusion, only secure the screw to the point that the pressure is firm

The alignment ribs on a bracket typically face the extrusion

Alignment ribs on a bracket provide strength for the bracket

Preloading brackets takes extra time and should be avoided

When preloading brackets, it's important to not tighten the nut all the way

When using extrusion, it's important that the nyloc goes inside of the extrusion rails

The flat side of the nyloc should face towards the extrusion

Which of the following is not a recommended practice for the REV DUO Build System?

Which of the following is not a REV DUO Build System actuator?

Ultraplanetary gearboxes offer designers a wide variety of gear ratios

Which of the following is not a recommended use for the HD Hex Motor?

The Core Hex Motor uses a female output shaft

All REV Build System motors utilize a built-in encoder

The Core Hex motor possesses a motion interface pattern

The Smart Robot Servo is not recommended for which of the following applications?

The Smart Robot Servo can be programmed for multiple different modes

The act of getting motion from one part of a robot to another is:

Transforming motion involves changing the torque or speed of the motion

Which of the following can't be used to transform motion in the REV Build System?

Gears always keep the direction of motion the same

What is not an advantage of using chain?

There are multiple ways to assemble chain

Which of the following gear systems would you want for a fast drivetrain

Gears can transform and transmit motion

It is critical to support motion on robots

Which of the following is not a wheel used in the REV Build System