WorksheetsDAY 43 WORKSHEET LSGD -ESTIMATION- TERMS,AREA,METHOD,MEASUREMENT
Total questions: 15
Worksheet time: 11mins
When preparing a detailed estimate, which statement is most accurate regarding tolerance and precision?
Linear measurements are rounded to the nearest 0.1 m
Areas are rounded to the nearest 0.1 sqm
Cubic contents are worked out to the nearest 0.01 cum
Heights are ignored in masonry calculations
In long-wall short-wall method, if wall thickness increases, which statement holds true?
Long wall length decreases and short wall length increases
Both long and short wall lengths increase
Long wall length increases while short wall length decreases
Lengths remain constant for both
Which of the following areas does not contribute to carpet area in a residential building?
Living room
Bedroom
Verandah
Kitchen
When calculating RCC quantities, which of the following is not deducted from the total concrete volume?
Openings for pipes
Steel reinforcement volume
Holes for dowels
Small voids less than 0.01 m³
Which of the following best defines “Centage charges”?
Contractor’s profit and overhead
Expenses on temporary sheds and watchmen
Departmental percentage added for design, planning, and supervision
Earnest money deposit
TRUE/FALSE
Work-charged establishment salaries are charged to the general establishment account (a)
TRUE / FALSE
In plastering measurement, no deduction is made for openings up to 0.5 sq. m, but one face is deducted for openings between 0.5 to 3 sq. m (a)
Assertion (A): Centre line method is preferred when all walls have the same cross-section. Reason (R): It simplifies calculation by avoiding repeated deductions at junctions.
Both A and R are true, and R correctly explains A
Both A and R are true, but R does not explain A
A is true, R is false
A is false, R is true
The total cost of construction including all expenditures incurred plus the cost of external services up to completion is called
(a)
The built-up covered area of a building measured at floor level of any storey is called
(a)
In estimation, the document used in tendering where rates and amounts are left blank to be filled by the contractor is known as (a)
When the engineering department executes works for another department, the percentage added to cover establishment and supervision expenses is called
(a)
Any item of work whose thickness is less than 20 mm is measured in
(a)
Match the following (Estimation Areas):
A. Plinth Area
Built-up area measured at floor level
B. Floor Area
Floor area = Plinth area – wall area
C. Carpet Area
Area actually usable inside walls
D. Circulation Area
Area for movement like corridors, verand
Match the following (Measurement Type):
A. Masonry
Measured in cubic meters
B. Plastering
Measured in square meters
C. Painting
Measured in running meters
D. Pillars
Measured in cubic meters using net volum
