What type of horizontal board siding is shown here?

What type of horizontal board siding is shown here?

Also known as drop siding or novelty siding, where joists are tongued and grooved or rabbeted and overlapped so that the lower edge of each board interlocks with a groove in the board immediately below it.

These are boards that interlap or interlock and have flush, V-groove, or beaded joints.

These are boards used with other boards and battens to protect and enhance the vertical joints and form patterns.

How would you classify these vertical board sidings: T&G siding, V-cute siding, and corrugated siding?

How would you classify these vertical board sidings: board and batten, batten and board, and board and board?

A kind of plywood with waterproof glue that is used outdoors.

This is manufactured from wood chips, curls, fibers, flakes, strands, shavings, and slivers, bound together and pressed into sheets, molded and shaped.

It is extensively used in "drywall" construction, where plaster is eliminated. Brand: Knauf, Gyproc (Saint-Gobain), Boral, and Elephant.

This manufactured board is composed of 72% Portland cement, 20% mineralized cellulose fibers derived from recycled materials, and 8% calcium carbonate.

Identify the type of steel stud shown here:

A masonry wall that utilizes steel reinforcing bars embedded in grout-filled joints and cavities to aid the masonry in resisting stresses.

A continuous layer of bricks, stones, or other masonry units.

A brick or block of masonry laid lengthwise of a wall.

A course of stones placed on top of the cornice crowning the wall.

The standard size (W x H x L) of a brick is...

These are structural units of clay or shale formed while in a plastic state and subsequently fired.

Also known as refractory brick. Used for the lining of furnaces, fireplaces, and chimneys.

Identify the brick bond pattern shown here:

Identify the brick bond pattern shown here:

Identify the brick bond pattern shown here:

This thickness of a CHB should only be used for interior partition walls where weather-tightness is not required.

True or False. CHB should be laid on a full bed of mortar

True or False. Reinforcements for wall footings shall be equal to 0.2% to 0.3% of the cross-sectional area of concrete, except for unusual cases.

A steel reinforcing bar, used in reinforced concrete, with the end bent into a hook to provide anchorage.

A horizontal structural member (such as a beam) over an opening that carries the weight of the wall above it.

It is a plastic mixture of cement or lime, or a combination of both, with sand and water, used as a bonding agent in masonry construction.

A type of mortar that is a proprietary mix of Portland cement and other ingredients, such as hydrated lime, plasticizers, air-entraining agents, and gypsum, requires only the addition of sand and water to make it.