Which of the following Gigabit Ethernet media has a Category 6 -UTP cable?

Which of the following Gigabit ethernet media has a 10-micron single-mode fiber?

It is a line code in which the encoding of each data bit is either low then high or high then low for equal time. 

1000BASE-TX operated over only two of the four pairs in the cable and requires __________ cabling.

Which of the following parameters is not applicable for a 10-Gbps Ethernet operation?

It is designed to operate over a 4-pair UTP cable and supports full-duplex data transfer at 1000Mbps. 

In a network using (OSI) architecture, the ____________ is the portion of the physical layer that interfaces with the data link layer's medium access control (MAC) sublayer, performs symbol encoding, transmission, reception and decoding and, performs galvanic isolation.

Which of the following is NOT a benefit of a Gigabit Ethernet on Fiber?

This version uses two strands of multi-mode optical fiber for receive and transmit.

This may introduce up to 140 bit-times of latency.

This may only introduce a maximum of 92 bit-times latency.

It is a port type for multi-mode fiber and single-mode fiber. It uses four separate laser sources operating at 3.125 Gbit/s and Coarse wavelength-division multiplexing with four unique wavelengths around 1310 nm.

It is particularly important in twisted-pair networks because signal integrity is dependent upon maintaining the differential relationship or “common mode” between the wiring pairs.

It is the term applied to transmitting Ethernet frames at a rate of a gigabit per second.

This links generally consist of a connection between a station and a hub or switch.

The ethernet can do the following process except for __________

It is also called thick Ethernet, ThickWire, and ThickNet.

200 Mbps transmission is possible because of the separate transmit and receive paths in ____________.

It is a binary code in which ones are represented by one significant condition, usually a positive voltage, while zeros are represented by some other significant condition, usually a negative voltage, with no other neutral or rest condition.

It is group communication where data transmission is addressed to a group of destination computers simultaneously. 

This can consume sufficient network resources so as to render the network unable to transport normal traffic.

It is the accumulation of broadcast and multicast traffic on a computer network. Extreme amounts of broadcast traffic constitute a broadcast storm.

A broadcast is forwarded across all bridges whether the receiving host is on the other side bridge or not. This eliminates the benefits of having a ____________.

This type of network is fine for an isolated network that does not require much data transmission.

Which of the following is not part of the STP states?

Latency in networks is measured in ____________.

It is also referred to as the IEEE way, is a design guideline for Ethernet computer networks covering the number of repeaters and segments on shared-access Ethernet backbones in a tree topology.

It happens when a switch receives the entire frame before sending it out to the destination port.

It is a logical division of a computer network, in which all nodes can reach each other by broadcast at the data link layer. 

It is a network protocol that builds a loop-free logical topology for Ethernet networks.

The data through a network flow from _______________.

It uses a table called the forwarding information base to control the forwarding of frames between network segments. 

The data stream and wire segments are part of the _________ layer.

It is the time it takes for data or a request to go from the source to the destination.

A process where a switch starts to transfer the frame as soon as the destination MAC address is received