NEW
Font size
WorksheetsEngineering Drawing and Tolerancing Quiz
Total questions: 22
Worksheet time: 11mins
In Europe drawings use first angle projection. This method is preferred by which standards organization?
ASTM
ANSI
ISO
SME
Which type of projection method is typically used in the United States?
First Angle
Second Angle
Third Angle
Right angle
In a drawing, views are always at __________ angles to each other.
Acute
Obtuse
Straight
Right
What type of section view allows internal features to be shown within a standard view?
Offset
Aligned
Removed
Broken out
Which of the following is most likely described using a one-view drawing?
Cylinder
Complex shape
Box
Sphere
Which type of drawing has the same level of detail as a two-view drawing?
Section-view
True-view
One-view
None of the above
What type of line is placed on a view to show the location of the section view?
Center
Auxiliary
Cutting plane
Object
If a drawing shows the right side view to the left of the front view, does that drawing use first or third angle projection?
First
Third
A sectional view provides __________ view of the object.
An internal detail
An external detail
Both an internal and external
None of the above
What is a view projected from a primary auxiliary view called?
Secondary auxiliary view
Tertiary auxiliary view
Second primary view
Side view
A normal die, such as what is used in a board game, would require what type of drawing?
One-view
Two-view
Three-view
Multi-view
The use of a center line plus the diameter symbol indicates that a part is __________.
Cubed
Flat
Uneven
Cylindrical
Dimensions provide __________.
The size of an object, its features, and each feature's location
The internal view of the object
Views that are not shown on blueprints
None of the above
Dimension lines are usually placed between two __________ lines.
Fault
Parallel
Extension
Internal
Which type of hole allows the head of a fastener to rest on a flat surface below the outer surface of the part?
Countersunk
Chamfered
Counterbored
None of the above are correct
What is a datum?
Threaded fastener
Countersunk hole
Feature symbol
Reference point
When the same type of arc is used in more than one place, what note is included with the dimension?
Repeat (REP)
Continuous (CONT)
Typical (TYP)
Again (AGN)
What purpose do extension lines serve?
Extend a dimension through a part
Combine multiple dimensions
Extend the dimension beyond the part's actual dimension
Move a dimension line away from the feature
Which of the following may be left off a linear dimension due to space and readability considerations:
Extension lines
Dimension lines
Dimension text
All of the above
How are angled surfaces dimensioned?
Surface
Linear measurement
Number and degree
Both B and C
The three most basic dimensions identified on drawings are __________.
Weight, height, depth
Width, depth, height
Weight, length, age
None of the above
What type of hole does not allow an object to pass all the way through?
Countersink
Thru
Blind
Threaded
