Details such as quality of materials and quality of workmanship are covered ____.

If there is a discrepancy between construction drawings and specifications, ____.

To find the circumference of a circle, multiply the diameter by ____.

A three-sided figure with an interior angle greater than 90 degrees is a(n) ____.

On the job, the most common fractions a mason will deal with are $$\frac{3}{8}$$ inch and ____.

The abbreviation ASTM stands for ____.

The common denominator of $$\frac{2}{3}$$ and $$\frac{3}{4}$$ is ____.

Construction drawings show the edges of objects that are not visible in a particular view by using a(n) ____.

On a six-foot folding rule, each inch is usually divided into ____.

Floor plans, foundation plans, and elevations are all considered ____.

A 10-foot wall built with 8 inch × 8 inch × 16 inch concrete block would be ____.

If the scale on a construction drawing reads 1/4" = 1'-0" and a dimension on the drawing is 2" long, the actual length of that dimension is ____.

The shortest leg of a right triangle is the ____.

Which of the following is NOT typically found on a set of architectural/engineering plans?

What is the sum of $$\frac{1}{4}$$ and $$\frac{3}{8}$$ ?

On construction drawings, which type of line is used to indicate the center of a circle or arc?